Best 20db Gain

RECOIL GLIRCA 2-Channel RCA Stereo Ground Loop Isolator Designed for Audio Signals Eliminate Noise

  • Eliminates ground loop noise between the audio source and radio. For use with portable devices that have RCA audio outputs, including pre-amp outputs.
  • Close to perfect response of +/- .03 db from 2 to 20,000Hz.
  • Utilizes proprietary audio transformers for a 1.3 dB gain.
  • Split pin RCA connector with pure Oxygen Free Copper wire.
Check Stock

E-outstanding 25dB HDTV TV Antenna Light Amplifie 1PC High Gain Low Noise Amplifier Kit TV HDTV Antenna Signal Booster Gain with USB Power Cable

  • Professional-grade cable TV and antenna signal amplifier with high 50dB output level. Supports TV coax cable signal from cable outlet, cable TV box, antenna, DTV, CCTV DVR, MATV or all other RF modulated TV system. Designed for large multi-dwelling units(MDU) that require precise RF amplification with gain and slope adjustments for a professional installation..
  • High-power amplification to compensate for the attenuations of the passive TV distribution components like cable, taps, splitters and cable outlets. Advanced CATV hybrid circuitry providing extremely low-noise figure and minimum distortion. Adjustable gain control and tilt control allows for easy system balancing..
  • Solution in solving the problems of noise, interference and weakness after distribution. Boost RF coax signal with ease for more than 2100FT or 650m if RF TV source signal has fair 70/75dB strength to start with. Boosts the existing CATV or antenna signal strength for greater distance with minimum loss for more TV distribution..
  • Adjustable gain/attenuation to reduce overdriving. Adjustable tilt compensation to allow large CATV systems to be properly balanced and mixed with other CATV or existing RF distribution system. Supports full TV frequency range from 40MHz to 860MHz for analog/di....
Check Stock

Sirio Antenna Siriosy 50-3 50-54Mhz 6 Meter Tunable 3 Elements Yagi Antenna

  • 6m VHF Base station antenna directional, high-gain horizontal polarization made of aluminum alloy 6063 T-832.
  • Type: 0.34 , 5 elements Yagi antenna frequency range: tunable from 50 to 54 MHz Impedance: 50 Gain: 8,4 dBd, 10,5 dBi.
  • Front to back ratio: 20 dB typical Max. Power (CW) 600 watts Connector: UHF-female.
  • Materials: aluminum, zamak, zinc plated steel dimensions (approx.): 3000x2060x100 mm / 9.8×6.8×0.3 ft..
  • Weight (approx.): 4000 gr / 8.8 lb. mounting mast: ø 35-50 mm / ø 1.4-1.9 in.
Check Stock

100dB Logarithmic Amplifier Module Dynamic Range Detection with Limiting Output for FSK PSK Demodulation 5MHZ‑500MHZ

  • WORKING PRINCIPLE - Logarithmic output of the logarithmic amplifier module is proportional to the logarithm of the input signal..
  • STABLE AND ACCURATE - ±0.4 dB RSSI linearity, RSSI scale does not change with temperature and feed voltage..
  • WIDELY USED - Used for received signal strength indicator (RSSI) and phase detection in cellular base stations, radar and other radio transceiver applications..
  • WITH LIMITING OUTPUT - AD8309 amplifier module, with limiting output, can be used as FSK PSK demodulation..
  • PARAMETER RANGE - 16mA current, 20 mV/dB slope, ‑95 dBm intercede, SMA female, 5MHZ‑500MHZ frequency range, 100 dB gain..
Check Stock

Audiopipe SPLIT-3113RMT Compact RCA 1 In-3 Out 10 Volt Audio Signal Splitter Line Driver with Remote Bass Knob for Car Audio Sound System

  • LINE DRIVER: 10-volt audio splitter signal line driver increases the output and lowers the noise, providing a more powerful signal for clear sound.
  • 1 IN/3 OUT: RCA 1 In/3 Out capabilities allows for versatile usage.
  • Input impedance/sensitivity: 47 kOhm/260mV.
  • DURABLE & DEPENDABLE: Made of tough materials to ensure lasting durability.
  • Designed for dependable operation with remote bass knob for customized use.
  • SLIM DESIGN: Compact audio device fits nicely in any sized car and doesn't encroach on interior space.
  • Dimension (L x W x H): 5.86 x 3.91 x 1.43.
Check Stock

Boss Audio Riot 1100-Watt Monoblock MOSFET Class A/B Amplifier & 2 CXX12 12' 1000 Watt 32Hz 4-Ohm Car Stereo Audio Power Subwoofer & Wiring kit

  • AMPLIFIER: 1100W Monoblock Class A/B Amplifier.
  • Switchable bass boost the low bass +18 dB.
  • AMPLIFIER SPECIFICATIONS: Total power output: 1100 watts.
  • Frequency response: 9 Hz to 50 kHz ±1 dB.
  • SUBWOOFER SPECIFICATIONS: Total power output: 1000 watts.
  • WIRING KIT: 20-foot 8-gauge red power cable.
Check Stock

Fosi Audio TDA7498E 2 Channel Stereo Audio Amplifier Receiver 160W x 2 and Box X2 Phono Preamp

  • TDA7498E: 160W X 2(4 ohms, 20 Hz - 20 kHz, 0.04% THD), for outdoor/ bookshelf/ computer/ desktop /ceiling /floor standing speakers, can use iPod,....
  • Adopt STMicro TDA7498E chip to get clear audio sound, No pop, no audible noise, dead silent when nothing is playing through it..
  • Box X2 Tube MM Phono Preamplifier: Converts phono signals to Line Level Signals with low-noise integrated circuits and high-quality components to....
  • Three switchable gain modes: 39, 42, 45 dB. Adjustable gain levels to give you customizable control and outstanding compatibility. Entry-Level....
  • 【What you Get】: TDA7498E Power Amplifier, Box X2 Preamplifier, Other Accessories, 18-month worry-free warranty and friendly customer service..
Check Stock

EC Buying AD620 High Accuracy Low Power Programmable Instrumentation Amplifier Module Voltage Amplifier Module Differential Amplifier Single-Ended/Differential Small Signal/Small Amplifiers Module

  • ♥Introduction: The AD620 is a low-cost, high-accuracy instrumentation amplifier that requires only one external resistor to set the gain over a gain range of 1 to 10,000. Ideal for portable (or remote) applications. With high accuracy, low offset voltage, and low offset drift, the AD620 is ideal for precision data acquisition systems such as electronic scales and sensor interfaces. Also features low noise, low input bias current, and low power consumption. The module has a fixed voltage output..
  • ♥Basic Features: ✭Module Name AD620 Instrument Programmable Amplifier ✭Module size:50mm * 50mm ✭Module power supply: 5V-24V ✭Module input signal type: single-ended signal or differential signal ✭Module signal input and output range: the input signal range is within 100 microvolts of the power supply, and the output signal range is within the power supply ✭Module bandwidth: AD620: 120KHz (G=100), AD623: 800KHz (G=1), AD620/623 is lower than 50KHz at high gain, and higher than 1MHz at low gain.
  • ♥ Other Features: ✭Module gain: When there is no solder slip, the AD620 will zoom by 10 times by default, and the AD623 will zoom by 20 times by default. During welding slip, AD620: G=1+50K/Rg, AD623: G=1+100K/Rg ✭Maximum magnification of the module: ....
Check Stock

UHF Fiberglass Mobile Radio Antenna,70CM 400-470mhz GMRS Base Antenna 17inch So239 Connector for Ham Radio Device Repeater Mobile Transceiver with Antenna Mount Bracket

  • [Directional YAGI antenna]Frequency:UHF 400-470MHz.
  • Polarization: Horizontal 3dB Beam Width: 53°.
  • [Simple construction,Easy Tuning and Assembly]The surface is made of aluminum alloy,Antioxidant,make the antenna bright and clean,sturdy and durable,good environmental adaptability.Lightweight,High strength,Waterproof,Corrosion resistant..
  • The body of the Yagi Antenna makes it highly resilient to outdoor use. Strong wind resistance,Rated wind velocity 60 m/s.Securely attached to the mounting surface with the U-Bracket..
  • High gain benefit,great front to back ratio.
  • Yagi Antenna greatly increase the signal strength of your radio,strong anti-jamming,provides stable signal,hit your repeater easily,get long distance communication..
  • Yagi Antenna Widely used in various directional divice:For Baofeng Motorola Yaesu Kenwood amateur 2 Way Radio.
  • satellite work,ISS (international Space....
Check Stock

BOSS Audio Systems AVA1210 7 Band Pre-Amp Car Equalizer with Gold-Plated Front Rear and Subwoofer Outputs

  • Front Adjustable EQ Band Frequencies: 125 Hz, 500 Hz, 3.5 kHz, 12 kHz.
  • Rear Adjustable EQ Bands Frequencies: 50 Hz, 600 Hz, 6.3 kHz.
  • Switchable Subwoofer Filter 32 Hz – 128 Hz, Frequency Response 10 Hz – 15 kHz.
  • Inputs: Dual 2 Channel Source. Outputs: Front, Rear & Sub. Fader Control.
  • Gain + / - 18 dB, Maximum Input Voltage 15 Volts, Maximum Output Voltage 8 Volts.
  • Signal to Noise Ratio 003e 110 dB, Channel Separation 20 dB, Total Harmonic Distortion 0.050.
  • Dimensions: Depth 4.6” x Width 7” x Height 1”.
Check Stock