Best 45 Degree Chamfer Reamer

MASTERCOOL 71700 Black Hydraulic Flaring and Swaging Tool

HAND-HELD HYDRAULIC PUMP requires a few simple pumps to flare and swage copper tubing.
45˚ FLARE includes sizes 1/4", 5/16", 3/8", 1/2", 5/8", 3/4" and 7/8".
EXPAND tubing using sizes 1/4", 5/16", 3/8", 1/2", 5/8", 3/4" and 7/8".
INNER-OUTER REAMER provides a full metal grip and is designed to remove inner burrs easily.

... surface is lubricated with grease to prevent rust, the thread is clear and easy to repair..
Easy to Use: The positioning groove of the die should be aligned with the fastening screw in the middle of the die wrench, and the screw should be inserted into the slot of the die and tightened. The end of the bar should be chamfered 1*45 degree, and the chamfer is too large to cut in..
Tips: It needs to be reversed every 1/4~1/2 turn to facilitate the chip discharge from the chip hole. Suitable lubricating oil should be added to the cutting edge of the die when tapping the thread. The bar diameter should be smaller ( about 0.05mm-0.15mm) than the nominal diameter of the required thread. Excessive diameter can easily cause difficult cutting and lead to damage to the die teeth..

Two openings in each wrench with 45° chamfer on wrench ends allow easy placement of wrench on the fastener.
Continuous arc design minimizes spreading and is stronger than “V” design.
Satin chrome finish provides good grip and cleans easily.

... surface is lubricated with grease to prevent rust, the thread is clear and easy to repair..
Easy to Use: The positioning groove of the die should be aligned with the fastening screw in the middle of the die wrench, and the screw should be inserted into the slot of the die and tightened. The end of the bar should be chamfered 1*45 degree, and the chamfer is too large to cut in..
Tips: It needs to be reversed every 1/4~1/2 turn to facilitate the chip discharge from the chip hole. Suitable lubricating oil should be added to the cutting edge of the die when tapping the thread. The bar diameter should be smaller ( about 0.05mm-0.15mm) than the nominal diameter of the required thread. Excessive diameter can easily cause difficult cutting and lead to damage to the die teeth..

ALUMINUM DESIGN ensures durability while also being light weight for easy portability.
CREATE 45˚ FLARES in soft copper, brass, aluminum and mild steel tubing.
FLARES SIX SIZES including 1/4, 5/16, 3/8, 1/2, 5/8 and 3/4″ O.D. Tubing.
KIT COMES IN BLOW MOLDED PLASTIC CASE with eccentric flaring tool, inner-outer reamer and heavy duty tube cutter for 1/8 – 1 1/8” O.D. Tubing.

The reamer range is 15/32 inch to 1-1/2 inch..
Product includes 11Pcs high speed adjustable hand reamers H4-H14..
The adjustable reamer is made of HSS(high speed steel) with good hardness and toughness..
Adjustable reamer is straight flute with straight handle..
The reamer is suitable for drilling machines and other machine..

The Flex-Hone for Chamfer Blending has the ability to blend and radius sharp edges and remove microburrs on chamfered holes eliminating stress risers caused by the chamfering operation.
Designed to polish and radius the outer corners (the intersection of the chamfer and flange face) as well as the inner corners and hole.
Polished and radiused chamfer surfaces have been shown to be very beneficial on critical rotating parts.
Suitable for finishing titanium, inconel, super CVM and nickel based stainless steel alloys.