2 Pack 2M 6.5ft RGB Extension Cable LED Strip Connector 4 Pin Solderless Strip Jumper Cables Kit with 4 Pack 4 Male Pin Connector for 5050 3528 RGB LED Strip Light
Compatibility: fit for all 10mm 4-pin RGB LED strip lights, for Both 5050/3528 RGB Waterproof and non-waterproof LED strip light..
Easy to Install: Solderless, installation without tools, save time. Make sure arrow to arrow, plug and play..
Operating conditions: The RGB LED strip light extension cable supports maximum wattage of 72W , and 0-24v voltage input. Suitable for most 10mm 4-pin....
2-pack extension cable: The RGB strip extension cables can connect between the IR/RF Controller and 5050/3528 LED strip light, extending strips to the....
What You Get: 2 packs 2M/6.5ft RGB Extension Cables, 4 pcs 4 male pin connectors, 8 pcs self-adhesive Cable clips, 30 days money back guarantee plus....
DORHEA 5PCS TM1637 0.56\ 4 Bits Digital LED Display Module with Clock Display 0.36 inch Common Anode Red Digital Tube Board with Cable for Arduino Raspberry Pi DIY Kits
The module is a 12 foot with a clock point four common anode tube (0.36 in.) display module driver IC is TM1637 driver IC TM1637, only two signal lines can make the MCU control 4 8 digital tube..
Display device is a total of 4 red LED word tube. Digital tube 8 grayscale adjustable. Control interface level can be 5V or 3.3V..
4-digit LED display module with LED brightness adjustable and clock point, can be used to display decimal, letters and so on, suitable for uses in induction cooker, micro-wave oven and small household electrical appliance..
Total 4 pins (GND, VCC, DIO, CLK), GND to ground, VCC for the power supply, DIO for the data input and output pins, CLK for the clock signal pin..
The Positioning holes in this LED Display Module 4 Bits has 4 M2 screws positioning hole diameter is 2.2mm and the positioning of the module is easy to install with easy to achieve the inter-module combination..
Nelyeqwo 2 Pack 5M 16.4ft RGB Extension Cable LED Strip Connector 4 Pin Solderless Strip Jumper Cables Kit with 4 Pack 4 Male Pin Connector for 5050 3528 RGB LED Strip Light
High Quality: The LED strip light extension cable insulation made of PVC material, anti-corrosion, wire contains 4 strands of tin-plated pure copper, which is resistant to oxidation, flexible and tough, durable and longer life.
Easy to Install: Solderless, installation without tools, save time. Make sure arrow to arrow, plug and play.
Operating conditions: The RGB LED strip light connectors support maximum wattage of 72W , and 0-24v voltage input. Suitable for most families.
Function: The RGB extension cable can connect between IR/RF Controller and 5050/3528 LED strip light, extend strips to the ideal location. Or connect between 2 RGB LED strips, convenient and practical.
What You Get: Cost-effective, 2 x 5M 16.4ft RGB Extension Cable and 4 x 4 male pin connector for 10mm 5050/3528 RGB Waterproof and non-waterproof LED strip light.
MEGA 2560 Starter Kit Ultra (100% Arduino IDE Compatible) w/ Battery Holder, Sensors, Modules, Resistor kit and Components (no Supply)
-Arduino MEGA R3 (generic high quality) + USB cable -6xAA Battery holder (9VDC) -WiFi ESP8266 module -Model Bluetooth Master / Slave HC-05 -Box with plastic cells (organizer of components) -Shield for prototypes + Mini-Breadboard -Large Breadboard (830 points ) -Dupont Cables 10 * Female-Female + 10 * Male-Female + 10 Male-Male -Cable Jumper for breadboard -6 Push Buttons with multicolored caps -Joystick Module type PS2.
-RC-522 RFID Module with white RFID Card and RFID Keychain -High-precision RTC Real-Time Clock Module DS3231 and EEPROM AT24C32 -PIR Presence Sensor HC-SR501 -Distance measurement module HCSR04 -Sound sensor detector module with programmable threshold -LM35 temperature sensor -Tilt detector module -Servo SG90 motor -Stepper motor (5V) -Motor driver module for stepper motor ULN2003.
Litever 6-Pack 3.3ft/1 Meter 9x18mm U Shape Aluminum Channels with Diffuser, End Caps and Mounting Clips LED Strip Channels for Max 16mm Wide LED Lightstrip Light Mounting--LL-007-M
Compact flat aluminum channels compatible for Lightstrip Plus 2nd. 6 pcs x 3.3 feet Aluminum Channels with frosted Covers + 12 sets of Accessories. (24 pcs end caps, 24 pcs Mounting Clips and Screws). ).
Aluminum channels diffusers wide enough for soldering-free easy connectors for 60 or 120 leds per meter 3528 led strips..
Aluminum channels with frosted covers wide enough for soldering-free easy connectors for single color or RGB 5050 led tapes..
Wider aluminum channels for many 12~16mm wide 3528 5050 5630 waterproof LED strips or any LED strip less than Width 16mm x Height 4mm..
This aluminum channel can NOT ensure a spotless lighting effect. No aluminum channel can ensure that. It greatly depends on "the distance between 2 leds" of your LED strips, the brightness of the LED strip, as well as the height of the aluminum channel. To get good lighting effect with this aluminum channel, we recommened LED strips more more than 120 LEDs per meter with high brightness. If you use 30 LEDs/Meter or 60 LEDs/Meter LED strips, the LED dots will be obvious but not that glaring..
Fntek 10Packs 4-Pin RGB LED Light Strip Connectors 10mm Unwired Gapless Solderless LED Tape Light Adapter Terminal Extension Connectors for SMD 5050 Multicolor LED Strip (10 Pcs 4PIN RGB Connector)
Application: Suitable for all 10mm wide (0.39 in) 4-pin SMD 5050 RGB flexible LED strips, making solderless and gapless connections for waterproof and non-waterproof LED light strips. Ideal for extending the LED strip and straight connection.
Easy to Use: Quick shunt connection and solderless snap down. Open the wire clamp. With a little effort, it will open quickly. Insert the 10mm LED strip into the clips under the two contact feet, making sure that the”+” and “-” correctly.
Fireproof Material: Fntek LED connectors are made from PBT material, which is heat resistant. 72W max wattage, which can be used for low wattage and high wattage light strips.
Note: Make sure you put the led strip under the pins and not on top. Please peel off silicon on the surface around soldering area when installing waterproof LED strips. Also be sure to cut along the suggested line evenly so there is room for a proper connection on each side.
Package: 10X 4 pin connectors for 10mm SMD5050 LED strip lights. If you have any questions, inquiries or need assistance, please feel free to contact us.
SUPERNIGHT LED Strip Lights 16.4FT 5M SMD 5050 Waterproof 300LEDs RGB Color Changing Flexible LED Light Strip for Bedroom TV Back Lighting Christmas Valentine s Day Black PCB
【Black FPC LED Strip Light】The FPC is black, which is different from most of white FPC strips. Perfect black FPC strip for you to decorate TV,....
【RGB Color Changing Rope Lights】The led chip is SMD 5050, and each LED contains R, G, B, three independent lamp beads. You can use one RGB remote....
【IP65 Waterproof Tape】This 16.4ft length flexible strip is waterproof(IP65),indoor use only. The polyester resin material covering the PCB to....
【Low Power Consumption Strip】This rope light works with 12V power adapter, low Power Consumption & environmental. Safe to touch. (DC 12V Power is....
【Best After-Sales Service】Please contact with us if our 5050 LED strip light can not work or has other problem. Professional SUPERNIGHT team would....
20 Pieces LED RGB Strip Light Connector Male and Female Connector Wire Cable 10 mm Wide Strip to Controller Adaptor with 10 Pieces Male 4 Pin Plugs for 5050 3528 RGB LED Light Strip
Package includes: you will receive 10 pieces of LED RGB strip light connectors to the RGB LED controller and 10 pieces of 4-pin male plugs for extending or connecting 5050/3528 4-pin RGB LED strips to the controller or 10 mm wide 4-pin flexible PCB connection.
Working conditions: this RGB LED tape connector supports 0 - 4A current and 0 - 24V voltage input, and the heat resistance class is -20 - 100 degree Celsius.
Easy to install: easy to install, no tools are required, no soldering, 5050 4-pin RGB LED strip connector kit, plug and play.
Good flexibility: flexible and durable wire, you can twist and extend at will, so your LED strip lighting system has no angle limit.
Note: when operating this connector, you need to process it into all the contacts that touch the correct point, and then lock it.
The dents on these connectors are small, which help to lock the placement of the strip, so it needs to be precise placement zone.
【RGBW LED Strip Remote Controller】This SUPERNIGHT remote controller with 5-Pin connectors is special for SMD 5050 chips RGBW color strips..
【Multi-Function Remote】There are 40 Keys on the remote, you can use it to turn led strip ON/OFF, change 20 colors, DIY modes as you like, set lighting modes, such as flash, jump, strobe and more..
【Output 12V 6A Max】Low power consumption, the perfect assembling part with 12V power adapter and 16.4ft 5050 300pcs led strip(not included)..
【Easy Installation】Please note that the arrow mark must be aimed at the arrow mark on the light strip..
【SUPERNIGHT Guaranteed】We offer this dimmer controller 30-day money-back guarantee for any reason + 12 month warranty for quality-related issues. Our friendly customer service staff will try our best to assist you fix the issue in 24 hours all year around..
