Best 5v Reed Relay

MEGA 2560 Starter Kit Ultra (100% Arduino IDE Compatible) w/ Battery Holder, Sensors, Modules, Resistor kit and Components (no Supply)

... temperature sensor -Tilt detector module -Servo SG90 motor -Stepper motor (5V) -Motor driver module for stepper motor ULN2003.
5V Active Buzzer -5V Passive Buzzer -LCD 1602 16 characters * 2 lines -LED Display Driver MAX7219 -LED Matrix Display of 8*8 -7 Segments Display 1 digit -7 Segments Display 4 digits -Simple Relay Module - Infrared Remote Control 38kHz - 38kHz Infrared decoder receiver (type 1838) - Infrared phototransistor (Flame sensor) - Infrared LED - Light sensor (Photoresistor).
-10 * LEDs 5mm Diffused RED -10 * LEDs 5mm Diffused GREEN -10 * LEDs 5mm Diffused YELLOW -5 * LEDs 5mm Ultrabright WHITE diffused -3 * LEDs 5mm Red / Green / Blue Diffused RGB -Shift Register (Series to Parallel IC) 74HC595 - NPN Transistor BC547 - PNP Transistor BC557 - Adjustable Knob Resistor 1kOhm (Potentiometer) - Adjustable Knob Resistor 10kOhm (Potentiometer).
- Resistor Pack 1/4W 1% accuracy, with 10pz of each value: 100, 220, 330, 470, 1K, 2K2, 4k7, 10K, 22K, 47K, 100K, 220K, 1M - 40-pin header 2.54 mm -40-pin header at right angle 2.54mm -5 * Capacitors for bypass tantalum 0.1uF -5 * Jumpers for header.

Kit includes Relay Buddy tester, 5 new relay adapters and blow mold case.
Relay Buddy is a quick go/no go tester for the most common automotive relays.
With the included adapters, Relay Buddy now tests 5 different relay types and also tests shielded relays.
Relay Buddy will fail the relay and light the red LED if any of the test cycle proves unsuccessful during the test session.
Settable to 4 and 5-pin relay and uses vehicle's 12 volts battery for power.

Able to test an entire circuit - from battery to component, including the relay With this item the technician can jump a relay.
do an AC charge from the relay by activating the compressor.
do compression testing by activating the starter relay and even check turn signals or lights from the front of the car.
Allows the technician to diagnose the problem without the use of a multimeter.
The lighted display shows the technician the problem immediately.
With this item the technician can jump a relay.
Includes: (1) Tester, (6) popular Relay Leads, and (1) Universal Relay Lead.

➤【Reed Switch】:Great for alarm,LED,Relay,GPS low voltage devices...etc.,Great for pick-ups with sliding rear window.Effective for Theft Deterrence..
Contact Capacity: 500(mA) (Maximum Switch Current).
Contact Type: NC/NO/COM,Trigger Range: 10-20mm.
This switch cannot exceed the DC12v power supply.
➤【Product Name】: Magnetic Door Swith.
➤【Safety Protection】: Magnetic Contact sensors can be added to an existing wired Alarm Systems. They are ideal for protecting doors,Surface-mounted magnetic contact, ideal wooden door or window use..
➤【Package Content】: 2 Sets x Magnetic Door Swith.
Size: 55*12.5*11.5mm / 2.17" x 0.45" x 0.45"(L*W*H) a package of screws for mounting on wood only..

Output: fan relay, alarm relay and 4-20ma current loop.
Controls: buzzer, Digital display, latching relay, relay Delay, relay minimum runtime.
Mounts on a standard 4” x 4” electrical box.
5 a spdt fan relay controls starters of exhaust fans.

MATERIAL: The bassoon reed is made of qualified bamboo stripe, solid, firm and durable to use..
GREAT ACCESSORY: The Bassoon Reed is a great accessory for bassoon. Altogether 5 bassoon reeds with cases will come to you, satisfying all your needs..
GREAT FOR BEGINNER: This Bassoon Reeds are playable as well as durable, these reeds are terrific for the beginning double reed player..
PRODUCT RICH SOUND: The Bassoon Reed with manually selected fine cane that will produce dark, rich sound with good intonation and nice response!.
REED LENGTH: Approx. 57mm / 2.24inch.The each bassoon reed with independent package makes it convenient for you to carry anywhere..

one latex reed and two super-thin prophylactic reeds with tuning fork cut in top reed.
One Latex Reed and Two Super-Thin Prophylactic Reeds with Tuning Fork Cut in Top Reed.

Output: fan relay, alarm relay and 4-20ma current loop.
Controls: buzzer, Digital display, latching relay, relay Delay, relay minimum runtime.
Mounts on a standard 4” x 4” electrical box.
5 a spdt fan relay controls starters of exhaust fans.

Tests 5 different relays, both 12V and 24V and 3 diagnostic trouble codes help define the cause of the bad relay.
Kit Includes 5 Relay Adapters and blow mold case.
Fails bad relays - Good/Bad indication, green light for PASS, red light for FAIL with flashing trouble code.
Tests 5 different relays, both 12V and 24V.
3 diagnostic trouble codes help define the cause of the bad relay.
#193 Kit Includes 5 Relay Adapters and blow mold case.
Quick off-the-car relay tester - checks relay coil & switch contacts.

Easy to setup,4CH Pro WIFI Wireless Dry contact Relay Smart Switch with RF Function,working power DC 5V or AC/DC 7-32,support 2.4G wifi only,when pairing,please make sure to put the relay close to your router,Once it’s powered on,if the indicator light flash 2 short 1 long,no need to long press pairing button,tap to pair in ewelink app directly..
3 working mode,momentary latching and interlock,set work mode as channel in ewelink app,you can set 2ch with inching for add wifi control togarage door opener,another 2ch self-locking to automate lights.
WIFI and RF Remote Control,with 433mhz receiver bulit in(433Mhz RF doesn’t include)support learning code 433Mhz RF only.4 button on the board,press each button to pair/remove RF as channel,independently control 4 appliance,real state feedback and historical operating discipline in ewelink app.
Timing and Sharing. Smart Scene: Trigger on/off by temperature, humidity or other environmental conditions,It supports 8 group timing function and Share Control with Family.
Voice Control,works with Alexa Google Home Nest IFTTT, Link "eWeLink Smart Home Fan" capability. You can request Amazon Echo / Echo Dot / Amazon Tap directly to turn your devices on / off.Remote ON/OFF Your Lights Garage Door on/off from anywher....