CTEK D250SE 20A 12V Battery Charger For Starter And Service Batteries In RV Truck And Overlanding Vehicles Solar Battery Maintainer 12V Lithium Ion Battery Charger And Smart Alternator Compatible
Battery Support On the Go: The D250SE is a fully automatic, 5 step charger that supplies up to 20A of power to any 12V lead-acid.
Achieve Nominal Power from Your Solar Output: Solar Panel Regulator with Maximum Power Point Tracking (MPPT) optimizes available power..
Charge Service and Starter Batteries: When the service battery is fully charged, the D250SE will automatically redirect maintenance charge power to....
Smart Alternator Compatible: Full functionality with all types of alternators..
Built-In Temperature Sensor: Allows you to achieve maximum charge levels no matter what the temperature..
This harness is a 3 wire MAF and a 1 wire alternator. For drive by cable throttle body Only..
Compatible with LS1 4L60E 2003-2007 Chevrolet, GMC, Cadillac and Hummer engine.
suitable for 03-07 all using 4L60E(Vortec engine 4.8 5.3 6.0) gearbox automotive..
All wiring harnesses come with the required instrument panel connections, including speedometer, tachometer, neutral, TCC, fault indicator and DLC port. Red/blue PCM connector and EV1 fuel injector connector..
The 1200-degree glass fiber braid and connector position lock on all circuits are heated before leaving the factory to improve the performance and efficiency of the engine..
The length of the 60-AMP relay harness has been increased by 36 inches, which is convenient for computer installation and easy installation, and there is a complete installation manual..
MaySpare Max 200A Trombetta Continuous Solenoid Relay 3 Terminal Heavy Duty Winch Marine 24106 SPST Solenoid 12VDC
Contacts:Normally Open (NO)/ Flat Base Metal Case / 10-32 Terminal.
3 Pole Battery Isolation Solenoid, 12VDC With 2 Copper Point,Housing plated Steel Case / 180Flat mounting bracket./ Mounting holes: 5/16 x 19/32, 2-13/64 on centers..
Our Coil Roll is using 180℃ Copper. Max Current Above 200amp/ Rate Current: 100A / Our Cover is Environmental Plating,Sealed Unit Protects Solenoid From The Elements Helping Prevent Corrosion.
INSTIALL:One side goes to Battery, opposite side to starter, top screw which is smaller goes to switch or key start only. It is already grounded internal..
Note:If it is the energizing circuit which is typically 16/18 Awg , suggest a 5amp fuse.
If 10 Awg wire suggest 30 amp auto cicuit breaker.
If high output alternator, suggest an 8 Awg wire with a 50 Amp auto circuit breaker.
MOTOPOWER MP0620A 4.2Amp Motorcycle Dual USB Charger Kit SAE to USB Adapter with LED Voltmeter and Ring Terminal Harness
REAL-TIME VOLTAGE DISPLAY- The built-in intelligent voltmeter with LED Digital Display let you know the real-time voltage status of the battery or the alternator. 12-24V DC Input..
SMART CHARGE with IQ Verify Technology- Dual USB Ports with 4.2A output. The IQ Verify Technology let the USB charger verify the phone model and brand before giving the proper charging current, so as to achieve the best charging performance. It can quickly charge almost any smartphones, tablets, GPS, digital camera, PSP/MP3/MP4 and other USB-devices..
SAFE CHARGE- Multi-Barrier Safety Protection - It's certified by CE & ROHS with Overload, Over Current and Short Circuit Protection to ensure charging safety..
LOW POWER CONSUMPTION - about 9mA power consumption in standby mode without load. No worry of battery draw. Monitor the battery voltage status all the time..
EASY INSTALLATION- With an additional 4FT long and fuse protected SAE Ring Terminal Cable for connecting directly with the battery easily. It also can be used for your battery chargers..