Battery discharge plug: red round banana plug. and attenstion: Red cable is positive, Black cable is negative. Charger plug: XH-3P.
Battery dimensions:90*35*16mm/3.56*1.35*0.63 inch. Upgrade capacity,real capacity is 2000-2100mAh. Voltage is 7.4V, Lipo rechargeable battery..
Please charge full the battery before use. 7.4V 2000mAh 2S Lipo rechargeable battery with banana plug replacment for Promark P70 RC Quadcopter Drone, battery replacement for S yma X8C X8W X8G X8HC X8HW X8HG X8 RC quadcopter drone..
7.4V 2000mAh 2S Lipo rechargeable battery with banana plug replacement for Vivtar DRC-446 RC Quadcopter Drone with Camera.
7.4V 2000mAh 2S Lipo rechargeable battery with banana plug replacement for RC Car truck RC vehicle ,RC Quadcopter drone ,RC helicopter, RC Aircraft and RC Buggy, which use same battery voltage size and plug..
JHSF doesn’t work unless the ambient temperature is below 37F/3 degree C. Please test the cable in a cold environment. HEATIT is registered Trademark by zhukeshi(We didn’t authorize other sellers in Amazon.com)..
Suitable for use on plastic and metal water pipes.( including inlet pipe,drain pipe, sewer , palm tree frost protection etc). Self regulating heating cable output will adjust automatically based on the ambient temperature at each point along the cable. No worry about the overheat risk. More Safe. Can be used by straight, spiral and overlap. More functional..
Pre-assembled, easy to install. Including grounded plug with light, built in thermostat(turn the cable 37F on 50F off), and instructions. 120 volt, 3 watts/ft at 50 degrees F. Energy-efficient. Protect pipes up to 2″ in diameter. For a better freeze protection, at least 1/2 inch thick insulation material is recommended, especially for extremely cold weather..
ETL approved. 2 ft 18/3 cold lead with plug. Industrial grade heat shrinkage tube for connection.The lowest installation temperature of this heating cable is -10 degree C. Tough XLPE as inner insulation and weather resistant PE (high-low temperature) as out jacket. Ingress Protection 65. Durable.
JHSF doesn’t work unless the ambient temperature is below 37F/3 degree C. Please test the cable in a cold environment. HEATIT is registered Trademark by zhukeshi(We didn’t authorize other sellers in Amazon.com)..
Suitable for use on plastic and metal water pipes.( including inlet pipe,drain pipe, sewer , palm tree frost protection etc). Self regulating heating cable output will adjust automatically based on the ambient temperature at each point along the cable. No worry about the overheat risk. More Safe. Can be used by straight, spiral and overlap. More functional..
Pre-assembled, easy to install. Including grounded plug with light, built in thermostat(turn the cable 37F on 50F off), and instructions. 120 volt, 3 watts/ft at 50 degrees F. Energy-efficient. Protect pipes up to 2″ in diameter. For a better freeze protection, at least 1/2 inch thick insulation material is recommended, especially for extremely cold weather..
ETL approved. 2 ft 18/3 cold lead with plug. Industrial grade heat shrinkage tube for connection.The lowest installation temperature of this heating cable is -10 degree C. Tough XLPE as inner insulation and weather resistant PE (high-low temperature) as out jacket. Ingress Protection 65. Durable.
JHSF doesn’t work unless the ambient temperature is below 37F/3 degree C. Please test the cable in a cold environment. HEATIT is registered Trademark by zhukeshi(We didn’t authorize other sellers in Amazon.com)..
Suitable for use on plastic and metal water pipes.( including inlet pipe,drain pipe, sewer , palm tree frost protection etc). Self regulating heating cable output will adjust automatically based on the ambient temperature at each point along the cable. No worry about the overheat risk. More Safe. Can be used by straight, spiral and overlap. More functional..
Pre-assembled, easy to install. Including grounded plug with light, built in thermostat(turn the cable 37F on 50F off), and instructions. 120 volt, 3 watts/ft at 50 degrees F. Energy-efficient. Protect pipes up to 2″ in diameter. For a better freeze protection, at least 1/2 inch thick insulation material is recommended, especially for extremely cold weather..
ETL approved. 2 ft 18/3 cold lead with plug. Industrial grade heat shrinkage tube for connection.The lowest installation temperature of this heating cable is -10 degree C. Tough XLPE as inner insulation and weather resistant PE (high-low temperature) as out jacket. Ingress Protection 65. Durable.
HEATIT HISD 18-feet Pipe Heating Cable with Built-in Thermostat
Use for water filled plastic (including PEX) or metal pipes. Not use for anything else, like empty water pipes, fuel lines, hoses, gutters, steam lines and so on. Two year limited quality . If you are not completely satisfied with HEATIT heating cable, please don’t hesitate to contact our customer service in any time, we’ll try our best to solve your issues..
Pre-assembled easy to install. Including grounded plug with light, built in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8” and less than 1 1/2” in. diameter. No crossing. No spiral. No overlap itself. Only straight..
Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When t....
HEATIT HISD 15-feet Pipe Heating Cable with Built-in Thermostat
Use for water filled plastic (including PEX) or metal pipes. Not use for anything else, like empty water pipes, fuel lines, hoses, gutters, steam lines and so on. Two year limited quality . If you are not completely satisfied with HEATIT heating cable, please don’t hesitate to contact our customer service in any time, we’ll try our best to solve your issues..
Pre-assembled easy to install. Including grounded plug with light, built in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8” and less than 1 1/2” in. diameter. No crossing. No spiral. No overlap itself. Only straight..
Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When t....
Splin All in One Wall Socket Mount Stand Holder Compatible with Smart Speaker Alexa Echo Dot 3rd gen —Amazon— Model Classic (Black)
✅ Cable Fee Beauty: Plug your Amazon Echo Dot 3rd gen. on the wall socket with no apparent cable. Design hides the power plug and saves room on the table.
✅ Awesome acoustics: Innovative design that hugs the Echo Dot 3 for a steady grip, without interferences to sound projection.
✅ Just plug it: 1- Fit power plug in | 2- Curl cable on proper compartment | 3- Fit the Echo Dot 3 in | 4- Plug the stand on wall socket.
✅ Absolutely safe: Tested by thousands of customers and many hours, this stand keeps tour Echo Dot device steady and safe, protected from pets or kids.
✅ 6 month guaranteed. No questions asked. Premium quality 3D printed.
Splin All in One Wall Socket Mount Stand Holder Compatible with Smart Speaker Alexa Echo Dot 3rd gen —Amazon— Model Classic (White)
✅ Cable Fee Beauty: Plug your Amazon Echo Dot 3rd gen. on the wall socket with no apparent cable. Design hides the power plug and saves room on the table.
✅ Awesome acoustics: Innovative design that hugs the Echo Dot 3 for a steady grip, without interferences to sound projection.
✅ Just plug it: 1- Fit power plug in | 2- Curl cable on proper compartment | 3- Fit the Echo Dot 3 in | 4- Plug the stand on wall socket.
✅ Absolutely safe: Tested by thousands of customers and many hours, this stand keeps tour Echo Dot device steady and safe, protected from pets or kids.
✅ 6 month guaranteed. No questions asked. Premium quality 3D printed.
Fancasee (2 Pack 3 ft) 5.5mm x 2.5mm DC Power Extension Cable 90 Degree Right Angle Male to Female Plug Adapter Extension Cord for IP Camera CCTV Surveillance Security Camera LED Strip DVR Router
L-Shape 5.5mm x 2.5mm DC power supply extension cable, convert straight plug to 90 degree right angle plug, male to female plug jack connector extension cord..
The 90 degree right angle plug jack cable can be easily go through the narrow gap, will never bend and damage the power supply cord..
This 90 degree right angle 5.5mm x 2.5mm DC power extension cable cord widely used for 12V 24V IP camera CCTV security camera surveillance standalone DVR LED strip router invoice printer low voltage application system etc..
Package contents: 2-Pack 5.5mm x 2.5mm DC power extension cable cord..
Fancasee (2 Pack 3 ft) 5.5mm x 2.1mm DC Power Extension Cable 90 Degree Right Angle Male to Female Plug Adapter Extension Cord for IP Camera CCTV Surveillance Security Camera LED Strip DVR Router
L-Shape 5.5mm x 2.1mm DC power supply extension cable, convert straight plug to 90 degree right angle plug, male to female plug jack connector extension cord..
The 90 degree right angle plug jack cable can be easily go through the narrow gap, will never bend and damage the power supply cord..
This 90 degree right angle 5.5mm x 2.1mm DC power extension cable cord widely used for 12V 24V IP camera CCTV security camera surveillance standalone DVR LED strip router invoice printer low voltage application system etc..
Package contents: 2-Pack 5.5mm x 2.1mm DC power extension cable cord..
