Best Cellulose Attic Insulation

Ducting Pipe Non Return Valve, Round Duct Rigid Tube Connector with Shutter Extractor Fan Backdraft Damper Stopper (4\ Inch, Damper)

  • 26 Gauge Galvanized Steel, Single Wall with No Insulation.
  • Built with standard plaster ground flange all the way around the square portion..
  • Connects a 10" Round Duct to a 14" x 14" Diffuser or Register Vent..
  • The ceiling box is nailed into the attic rafters and plastered or dry walled around the flange called plaster ground..
Check Stock

Ventamatic XXDUOSTAT Adjustable Dual Thermostat/Humidistat Control for Power Attic Ventilators

  • THERMOSTAT/HUMIDISTAT CONTROL: The Dual Thermostat and Humidistat is designed for use with Power Attic Ventilators. The dual controls allow for a user to limit the operation of the fan based on user selected temperature and humidity levels..
  • ADJUSTABLE DUOSTAT: This item is often called a Duostat and is an essential tool for homeowners to regulate the temperature and humidity levels while preventing their power attic ventilator from running in continuous operation mode.
  • ENERGY EFFICIENT POWER ATTIC VENTILATOR: It provides energy-efficient operation of power attic ventilators and the temperature ranges from 50°F to 120°F..
  • DUAL HUMIDITY CONTROL: Adjustable Thermostat and Humidistat Control has 10 Amps, 120 Volts AC. Thermostat setting adjusts from 60 - 120 degrees F (normal settings are 85 - 110 degrees F). Humidistat setting adjusts from 30 - 90% (normal settings are 60 - 70% depending on local humidity levels). If either setting is too low, fan will run continuously. If setting is too high, ventilation will be inadequate. It has limited lifetime warranty..
  • REMOVAL OF HEAT: The Duostat allows for worry free operation during both winter and summer months by allowing the homeowner to not manually turn on and off their attic fan when needed. It remov....
Check Stock

HALO Recessed H36TAT Housing Non-Ic Air-Tite Shallow Ceiling 120-Volt Line Voltage,Green,197

  • Air-tite construction helps prevent air flow from the attic to the living space.
  • 3 in. aperture provides illumination for your general lighting needs.
  • Use for new construction where insulation will be kept 3 in. away from all sides of the housing.
  • Compatible with 120-Volt GU10 lamp (sold separately).
  • Pass-N-thru bar hangers for easy installation.
  • Slide-N-side junction box allows wiring connections to be made outside the box.
Check Stock

H1499 4 in. Steel Recessed Lighting Housing for Remodel Shallow Ceiling, Low-Voltage, No Insulation Contact, Air-Tite

  • Air-Tite rated design meets restricted air flow code requirements which prevents airflow between attic and living areas and saves on both heating and air conditioning costs.
  • Has four remodel clips which secure the recessed housing and accommodates 1/2 in. and 5/8 in. ceiling material.
  • Compatible with a wide variety of 4 in. low-voltage recessed light trims but is best with Halo 1496, 1493, 1421, 1420 and 1419 series models.
  • NM cable pryouts and conduit knockouts in junction box.
  • Can be installed from below the ceiling in home remodel applications, ideal for those who have limited or no access to their ceiling.
  • For use in non-insulated ceilings or insulated ceilings where insulation is kept at least 3 in. from all sides of the recessed light fixture.
  • 3 "Quick Connect" connectors eliminate the need for separate wire nuts - simply strip supply wires and push in.
  • Listed for damp location when used with dedicated wet rated recessed ceiling lights.
  • Features an integral thermal protector to guard against misuse of insulation materials and improper lamping.
Check Stock

Tamarack TTi HV1600 R38 Whole House Fan (2 Speeds), Insulated Quiet Cool Attic Fan with Remote and Self-Sealing Doors, Duct Free Whole House Attic Fan Improves Air Quality

  • QUALITY AIRFLOW - Tamarack Technologies’ remote-controlled HV1600 Whole House Fan allows you to avoid using your AC when the outdoor air is cooler than the indoor air. The attic exhaust fan pushes hot air, indoor air pollutants, allergens, moisture and odors out through attic vents or gables while pulling cool, fresh air naturally cooling your home and improving the indoor air quality..
  • SELF-SEALING DESIGN - The attic fan includes R38 insulated doors that open automatically when the fan is operating and seal shut automatically when the fan is off. The insulated door design prevents cool air from escaping your living area to the attic..
  • COST-EFFICIENT - Our whole house fans for home have insulated doors that prevent heat loss through the attic during the cooler months. Installing a Tamarack Whole House Fan reduces energy consumption and saves money. Our household ventilation fans use only 10% of energy a central air conditioning system uses and reduces your energy bill..
  • LONG-LASTING AND MADE IN USA - Made with durable metal material, this quiet cool whole house fan is covered by a lifetime manufacturer's warranty. Th....
Check Stock

BJTDLLX 12 Steps Wall Mounted Folding Stairs, Attic Steps Pull Down Attic Stairs Retractable Attic Ladder Al-Mg Alloy Loft Ladder Stairs 3m Height Attic Steps with Armrests (Weight Capacity 1000lb)

  • 【Attic Wall Stairs】Wall-mounted attic wall staircases are becoming more and more popular recently due to their simplicity, elegance, practicality, retractability and small footprint. Attic Wall Ladder Stairs meet most people's needs for a stylish and uncluttered lifestyle..
  • 【Wall Mounted】This attic wall ladder is wall mounted, the frame size is 60x70cm (please refer to the picture), the drop-down attic staircase can install the frame on the vertical wall or vertical plane, but cannot be installed on the ceiling and pulled from the ceiling down..
  • 【12 Steps】The 12-step drop-down attic staircase aluminum has a maximum vertical height of 3 meters/9.8 feet and a step width of 43 cm/16.93 inches. Wall Mounted Loft Wall Ladder Stairs can be used with a simple pull down. You can remove steps to lower the maximum height..
  • 【1000lb Load Capacity】The maximum load capacity of wall mounted attic stairs is 1000 lbs, the step ladder can be widely used in attics and cabin tops, making it easier for you to go up and down the stairs (for your safety, please do not stand multiple people at the same time)..
  • 【Aluminum-magnesium Alloy Material】The attic wall ladder stairs are made of aluminum-magnesium alloy material, which is stable in quality, d....
Check Stock

DAP 7565002110 Touch ‘n Seal 110 Low GWP 1.75 PCF FR ICC Closed Cell Spray Foam Insulation Kit with Pre-Connected Hoses

  • Low Global Warming Potential (GWP), Airseals and saves energy, High r-value 6.6 @ 1″ (25mm).
  • Class A fire rated, Closed cell structure, Does not shrink or settle.
  • Compatible with all fiber insulation systems including cellulose, fiberglass and stone wool.
  • Significantly increases structural strength, Reduces sound transmission.
  • Theoretical Yield: 110 Board Feet (1 BF = 12″x12″x1″ thick), Dry/Tack Free Time : 30 – 60 Seconds, Cure Time (Tack) : Approx. 1 Hour.
Check Stock

DAP 7565002750 Touch N' Seal 750 Low GWP 1.75 PCF FR ICC Closed Cell CPDS Spray Foam (NOT a Standalone Kit, CPDS Machine Required)

  • A CPDS Machine Required to Dispense this product..
  • High r-value 6.6 @ 1″ (25mm), Airseals and saves energy, Theoretical Yield (Board Feet) : 750 BF (1 BF=12″x12″x1″ Thick).
  • Closed cell structure, Class A fire rated, Does not shrink or settle.
  • Compatible with all fiber insulation systems including cellulose, fiberglass and stone wool.
  • Significantly increases structural strength, Reduces sound transmission, Low Global Warming Potential (GWP).
Check Stock

HALO E26 6 in. Aluminum Recessed Lighting Housing for Remodel Ceiling, Insulation Contact, Air-Tite, (E7RICAT)

  • Can be installed from below the ceiling in home remodel applications, ideal for those who have limited or no access to their ceiling.
  • Insulation contact rated: Designed for insulated ceilings where contact is necessary.
  • Air-Tite rated design meets restricted air flow code requirements which prevents airflow between attic and living areas and saves on both heating and air conditioning costs.
  • Exclusive remodel speed clamps securely lock from 3/8 in. to 2 in. ceilings eliminating the struggle often experienced with recessed housing clips.
  • Compatible with a wide variety of 6 inch Recessed light trims but is best with Halo 426, 420, 353, 310, 301, 172, 78, 71, 70, and 30 series models.
  • Compatible with a wide variety of 6 inch LED retrofit trims but is best with Halo quality RL, RA, SLD, LT, SMD, and ML series models (Bulb free with some having a 45 year LED lifespan).
  • High performance E26 Series 6 inch trim options available.
  • Socket bracket adjusts lamp to various trim styles and designs.
  • Three Quick Connect connectors eliminate the need for separate wire nuts - simply strip supply wires and push in.
  • Features an integral thermal protector to guard against misuse of insulation materials and improper lamping.
Check Stock

Ventamatic XXFIRESTAT 10-Amp Adjustable Programmable Thermostat with Firestat for Power Attic Ventilators, Replacement Thermostat

  • FIRESTAT THERMOSTAT: The Ventamatic Firestat Thermostat controls power attic ventilators. The Firestat Temperature Range is 183°F at which point it cuts off the appliance..
  • ADJUSTABLE THERMOSTAT: The Thermostat is adjustable by the use with a simple screw driver adjustment. It has adjustable bi-metallic switch..
  • ENERGY EFFICIENT POWER ATTIC VENTILATOR: It provides energy-efficient operation of power attic ventilators and the temperature ranges from 50°F to 120°F..
  • REPLACEMENT THERMOSTAT: This Ventamatic Replacement Thermostat controls power attic ventilators to promote the equalization of temperatures inside and outside your attic. Firestat safety feature shuts fan off at 183F Controls up to three units, not to exceed 10 amps..
  • PROGRAMMABLE THERMOSTAT WARRANTY: This thermostat provides 10 years of warranty. It is of opening size 4.8 x 2.5 x 4.8 inches.
Check Stock