Signaworks LED 4 Light Steady & Flashing Andon Tower Light Kit - Parts Only Assembly Required - 3 Position Switches for On/Off Operation - Stack Light…
...or Budget Minded Facilities to have Custom Andon Lights Stations, including Direct Wire, Extended Cable, Conduit, etc. These parts can build an Andon Light with Stack Light with a pole attached to a switch box and power cord..
CUSTOMIZABLE ANDON PARTS KIT INCLUDES: Bright LED Tower Light 110VAC, 10" Threaded Pole w/ Mounting Nuts, Right Angle Mounting Bracket, Selector Switch Box with Color & Switch Operation Labels, Drilled Holes for Light, Power Cord, Four 3 Position Switches with N.O. contacts, 3 Prong Power Cord, Cable Gland, Butt Splices, Terminal Connectors & Wiring Instructions. DOES NOT INCLUDE (Required): electrical knowledge/aptitude, screwdriver, wire stripper/cutter, wrenches, multimeter, crimper..
SUPER BRIGHT, LONG LASTING LED ANDON STACK LIGHT - Using Super Bright LEDs with Long LED Life, the Highly Visible Signal Light provides LED Lighting Over the Full Surface of the Lens Section (Not like other cheap, spotty LEDs or replaceable bulbs). Lenses are replaceable in case of damage and should last for 10+ years in most applications..
ECONOMY SOLUTION - Buying Parts and Putting Together your Andon Signal Light Station Yourself can be a Cost Savings and Provide you with the Exact Signaling Solution you are looking for. If you are look....
Compatible with two-piece splitboards that are drilled through at the clip mounting points. (you can see screw heads on the base of your board.).
Not compatible with boards that have inserts rather than holes at the clip mounting points. For these boards please see Spark's Top-Mount Fixie Clips..
Not compatible with three or four-piece splitboards..
Includes: 2 left clips, 2 right clips, (8) 12mm screws (for thin boards), (8) 14 mm screws (for thick boards), 4 grip nuts, 2 square nuts..
Wall Bracket for Gridwall - Use to Mount Wire Grid to Wall BLACK Lot of 50 NEW
Use our gridwall mounting clips to easily mount & secure your grid panels flush against your wall. Our mounting brackets come in a black finish and will hold grid panels with up to 1/4" thick wire..
Simply place the grid against the wall, secure the bracket across the wire & screw it into the wall. The bracket mounts have a small half circle loop that goes over the wire. No screws are included..
They measure .5" H x .78" L and have a 1/5" diameter hole so you can easily screw the panel into your wall..
NOTE: These clips need to be screwed directly into the stud of your wall. They may not securely hold your panel if it's screwed into sheet rock. We recommend at least 10 clips for a 2' x 6' panel..
