Voltage Amp Meter DC DROK Battery Monitor DC 0-300V 200A Ammeter Voltmeter for Solar System Setup Power Energy Capacity Volt Current Detector Panel with Hall Sensor
Multifunctional Meter: DROK multimeter panel is available to measure percentage and AH of remaining capacity, DC positive and negative bidirectional....
Hall Sensor & Easy Mount: the voltage amperage meter is coming with a Hall transformer to for isolated measurement, reliable and safe.
Display: backlight can be controlled to be ON or OFF as user’s need.
Equipped with full angle of view LCD screen, users could see the display....
Alarming Function: it will alarm and flash to draw your attention when the real voltage is higher or lower than preset alarming voltage and real....
Wide Applications: Can be used as dc amp meter, digital volt meter, power meter, battery capacity monitor. Suitable for all kinds of batteries, such....
Facmogu 12V 2A 24W Power Supply Adapter with Car Cigarette Lighter Socket, AC 100V-240V to DC 12V 2A Voltage Transformer US Wall Plug Amp Converter AC to DC Switching Power Adapter
Convert 100V~240V AC household current into 12V 2A DC power supply, equipped with LED charging indicator, and the cable length is 90cm (3ft)..
NOT Available for High Power: This car cigarette lighter is ONLY suitable for some low-power car equipment, such as car mp3, oxygen bar, humidifier and so on, NOT for high-power devices (such as high-power car air compressors, waxing machines, etc.) to achieve home use..
Multiple Safety Protections such as: Anti EMI Interference, Surge Protection, Short-Circuit Protection, Over-Load Protection, Over-Current Protection and Over-Temperature Protection etc..
NOTE: It should be 12V DC, not be AC 12V or lower/higher than 12V DC. Please make sure that your vehicle electronic products with rated power less than 2A 24W..
Standard US 2-Pins Plug & Female Car Cigarette Lighter Connector. (Please check the power input connector of your device. It should be standard male car cigarette lighter plug.).
Tempo Communications PE2003-G Pulser Ground Fault Locator (Latest Model)
Identifies the exact location of even the smallest breaks in insulation by "pulsing" a high-voltage signal that radiates into the earth at the location of the faults. With the A-frame mounted receiver, a visual analog meter points the way to the source of the voltage.
Multiple faults on a single wire can be identified indicating the need to replace instead of repair.
Extra-long test leads feature heavy-duty alligator clips for use on multiple cable types.
Includes a rechargeable transmitter, receiver, A-frame, ground stake,120V charger and a 12V DC (cigarette lighter) adapter.
Battery operated (one 12V and one 9V battery are included).
Satellite finder Signal Finder, VISLONE HD Satellite TV Signal Finder ST-5150 DVB-S2/T2/C COMBO Digital Handheld Signal Meter Satellite Finder H.265 HEVC MPEG-4 4.3 Inch TFT LCD US Plug
WS-6980 is a DVB-S/S2/T/T2/C and MPEG-2/4 H.264/h.265 (Just support 8 Bit, not suppport 10 Bit) compliant handheld combo meter. With its compact size, light weight, intuitive user's interface, long battery operational hours and rich feature set, the meter provides all functions needed for installation and verification of digital Satellite TV service, antenna signal and cable signal to residential homes or multi-dwelling unit. Currently, WS-6980 can only support 1080P and cannot support 4K..
7 Inch High Definition TFT LCD Screen(1024*600) .Fully DVB-S/S2,T/T2/C, MPEG-2/MPEG－4 compliant, MPEG-2 / MPEG－4 H.264 Hardware decoding..
Supports scan of Auto, Manual ,NIT(DVB-S/S2).
Supports DISEQC 1.0/1.1/1.2 ,0/22khz Tone.
Independent battery charging power. Software upgrade via USB port,..
Streamlight 75458 Stinger DS LED HL 800-Lumen Rechargeable Dual Switch Flashlight with 120-Volt AC/12-Volt DC Smart Charge Piggyback Charger (NiMH), Black
3 Lighting Modes: High for maximum illumination with 800 lumens and 310 meter beam, Medium for intense brightness and longer run time with 400 lumens and 219 meter beam, and Low for extended run time with 200 lumens and 155 meter beam.
Dual switch technology with both tail cap and head mounted switches that operate independently for maximum versatility.
3-Cell, 3.6 Volt Ni-MH sub-C battery, rechargeable up to 1000 times.
Smart PiggyBack charger: Fully recharges within 7.5 hours (5V/1A USB input) or 4 hours (12V DC input).
Machined aircraft aluminum body with non-slip rubberized comfort grip.
Tnuocke 12V 5A 100V-240V AC to DC Power Adapter 5.1x2.1mm 8-Way Power Splitter Cable for CCTV/Camer/DVR H-M-025
Parameter：Input voltage:AC 100-240V~50/60Hz, output voltage: DC 12V, output current: DC 5A..
8-way splitter cables: 16.5inch,Plug Diameter, 5.5 mm Outer, 2.1 mm Inner..
Package：1 set of DC 12V 5A power adapter (including cable) and 8-way splitter cables..
Easy to use: just plug the power adapter into the power supply, and it can be used. Eight power lines can supply power for multiple electronic devices..
Applied range：Very suitable for closed-circuit television and video cameras in home or office..
UPBRIGHT 24 Volt AC/DC Adapter Compatible with Pulse Performance PPP Products EM1000 Vehicle ATV 24V 100W Electric Dirt Bike 978701-D 978701D EM-1000 E-Motorcycle 24VDC Power Supply Battery Charger
...Performance Products 24 Volts Electric Sonic Scooter.
⚠️!!!Note: Rechargeable batteries don't last forever, the average battery last 1 to 3 years. If the battery is old/dead, it will not accept a charge. But not charger's problem. If you're not sure whether battery or charger is dead or not. You must have a volt meter in order to tell whether or not a charger is working..
KAIWEETS HT208D Inrush Clamp Meter 1000A True RMS AC/DC Current Amp Meter VFD LOZ Mode 6000 Counts Measures Current Voltage Temperature Capacitance Resistance Diodes Continuity Duty-Cycle
True-RMS Clamp Meter: This multimeter can accurately measure 1000 Amp AC/DC Current, 1000V AC/DC Voltage, Frequency, Duty Cycle, Resistance, Capacitance, Diode, Continuity, and Temperature. Easy to use for labs factories and households..
Inrush Current Meter: Knowing the value of inrush current can help you locate a startup problem quickly, whether it's in the motor or in the starting circuit. The measuring time of the inrush current is about 100ms. When the current is greater than 10A, the Inrush function works well. The inrush function is only available in AC current mode, DC current does not have the inrush function..
NCV Detection & LED Flashlight: Built-in Non-Contact Voltage (NCV) Detector can easily and quickly determine whether there is a voltage. A convenient LED flashlight illuminates a dimly lit area..
Advanced Functions: The Clamp Meter has Variable Frequency Drive Filtering (VFD) and low Input Impedance (LoZ) modes, which can provide higher accuracy readings..
Safety Service: Safety standard IEC 61010-1, CAT IV 600V, CAT III 1000V. Double insulation. Use high-quality material, to prevent electric shock harm. 36-Month product service provided. 7/24 Customer Service..
