✔【FAST AND ACCURATE RESPONSE】-----This 3044196 electronic speed controller with full closed-loop control technology, it is the moment to load changes with fast and accurate response to control engine speed, when connected to the matching EFC Series electric actuators and magnetic speed sensor signal , can be perfectly controlled engine..
✔【PREVENT REVERSE VOLTAGE】-----In the design, it is easy to install and can be pre-adjustments, including adjusting the idle speed and work, to assist for input multiple machines or special purpose machines, as well as to prevent reverse battery voltage, transient voltage pulse implementation of the short-circuit fault and security in case of loss of speed sensor signal or power supply and so on..
✔【FULL CLOSED-LOOP CONTROL】-----High quality 3044196 electronic speed controller, stable performance. Full closed-loop control technology. Fast and accurate response to control engine speed.
✔【EASY TO INSTALL & PRE-ADJUST】-----It is easy to install and can be pre-adjustments. For input multiple machines or special purpose machines..
✔【OPERATING FREQUENCY OF 3800HZ】-----The above performance parameters are measured at the operating frequency of 3800Hz..
MEISHILE DC 12V 50A 600W Switch Power Supply 110V AC to DC 12 Volt 50 Amp SMPS Converter Power Supply Adapter Transformer
...awn by your device. The total output current/power can not exceed 80% of the rated power of the power supply.
☆ Portable, Small and Compact: 21.5×11.5×5cm/8.5×4.5×2 inch, Net weight 0.8 kg. SATISFACTION GUARANTEE: For any question, do not hesitate to contact us, we offer you a satisfaction guaranteed.
☆ High EFC, Low-loss, Long Service Life: More than 6,000 hours of service life.
Low standby power consumption, High efficiency. EFC much higher than linear supply. Safe and Stable: Power Supply has over / under voltage, over heat protection, continuous fan heat dissipation. Strictly tested before leaving the factory..
☆ Choose: The Rated Power is the Peak Power, does not mean that it applies to devices at this power (watt). For resistive device, SMPS peak power ≥ device power × 1.25 times. For Motor device, the peak power of the SMPS needs to be more than 2 times the power of the Motor. Same goes for Rated Current..