Banda 1-Channel Vehicle Audio Bass Amplifier - High-Powered Mono Bass Amplifier w/Subsonic Filter and Low Pass Filter Stable at 1 ohm LED Indicators Sound Specialization - BANDA VIKING8001
POWER SUPPLY: Class D vehicle audio amplifier, Total Power 14,4 @ 1 Ohms: 9500 WRMS, Total Power 14,4 @ 2 Ohms: 7400 WRMS, Total Power 12,6 @ 1 Ohms: 8000 WRMS, Total Power 12,6 @ 2 Ohms: 6100 WRMS, Efficiency @ 2 Ohms: 83%, Efficiency @ 1 Ohms: 73%.
MONO BASS AMPLIFIER INDICATORS: Blue LED: source and powered amplifier indicator, Red LED: output distortion (clipping), Constant - output short circuit indicator, Yellow LED: low voltage battery, Constant - Fuse blown or missing.
POWER OUTPUT AND IMPEDANCE: Input Voltage: 9 to 15V, Input Impedance: 22K Ohms, THD + Noise: less than 1%, Input Sensitivity: 160mV – 600mV, Signal to Noise Ratio: 80dB.
SOUND SPECIALIZATION: This high-powered Power Amplifier is cutting edge technology at its finest. RCA connectors ensure a secure connection between amplifier and speakers that allow distortion-free sound.
OTHER TECHNICAL SPECS: Recommended Fuse: 400A, Current at Rest: 4,5A, Ave. Current Draw (Sinusoidal): 920A, Ave Current Draw (Music): 400A, Power Wire Gauge: 50mm/0 AWG, Speaker Wire Gauge: 2 x 6mm / 2 x 3 AWG, Size: 2.4’’ x 10.6’’ x 17.7’’.
Leviton 47605-PSC Versatile Power Supply for Structured Media Cabinet
LED: This Green LED will illuminate when input AC power has been applied to the unit and DC power is available.
Fuse: If the AC/DC primary circuit load or if the DC output load increases, causing the input AC current to the DC power supply to exceed the 2 Amp....
This will cause the DC power supply to loose all DC power output but AC power output to the NEMA 5-15 Receptacles will remain active.
This unit connects to a 120 VAC, 3 wire source and provides 6 DC outputs at 12 Volts.
NEMA 5-15 Receptacles: These two AC output female connectors will provide 120 VAC and UL rated at 15 Amps total.
Electric Fan Wiring Kit Electric Fan Relay Kit with Thermostat Radiator Fan Sensor Switch Electric Cooling Fan Thermostat Kit Temperature Sensor Switch 185 On 175 Off, 40 AMP Waterproof Relay Kit
Easy to follow wiring diagram simplify wiring your electric fans. RED to 12VDC positive battery terminal, COFFEE to Fan Positive, BLACK to Ignition, GREY to Sending Unit per wiring diagram. Direct replacement part fits 10, 12, 14, and 16 inch cooling fans. For dual fan wiring, you would need two of this relay kit.
Temperature switch turns on fan approximately at 185 Degrees and Off at 175 Degrees. The temp sensor has a 3/8 inch pipe thread, and a 1/2 inch adapter included.
This electric cooling fan thermostat kit comes with everything you need, includes 40A waterproof relay, wiring harness, temperature switch, 3/8 inch to 1/2 inch adapter, inline fuse holder, 20 amp fuse, 4 ring terminals and 2 fan pigtail connectors.
The thermostat supplied with this kit is OE style to mount in the cylinder head of the engine or any water jacket if needed.
If you intend to mount high-profile fans, you could crimp or solder bigger wires to it. The 14AWG wires (15 amps) are not bigger enough for high amps draw.
LEDeXTREME Ultraviolet Black Light Night Fishing Light LED Light Strip, High Power, 16.5ft, Waterproof IP68 for Bass Boats and Pontoons
...ofessional installation. Includes 4 pcs 40 inch Black Light LED Strips with black PCB background and adhesive backing 2 each 12 inch green strips for mid-boat rub rail mounting, Navigation Strips:1pc 12 inch Red and 1pc 12 inch Green LED Strips, 30ft 22 gauge Power Wire. 1pc Waterproof Pushbutton Switch. Wire Crimp Connectors. Fuse and fuse holder. All LED Strips include Double sided tape pre-installed.
PRO-GRADE – ULTRA-VIOLET BLACK LIGHT STRIPS – Our LED strips have been specifically designed with the night fisherman in mind. Our Black Light LED strips are TRUE Ultra-Violet, not purple or pink like the rest. Our Black Light Strips will illuminate an extremely wide area. Illuminates underwater trees, stumps and of course your white, yellow, and green monofilament fishing line as well..
BASS BOAT RUB RAILS – Unlike the others, our kit includes Red & Green Navigation led strips. Easy DIY installation with written instructions provided.
ALL BLACK BACKGROUND. All LED strips include black background and will blend in perfectly with your rub rail. 40″ Ultraviolet strips include 8ft power cable pre-installed and we include 30ft of extra power cable as well..
...Kit Features:(1)High Grade Twisted Pair 100% Copper RCA Cables,(1)Blue Super Flex Power Cable,(1)Black Ground Wire,(1)Black Remote Cable and (1)Remote control,(1)Black Split Tube,(1)Speaker Wire,(1)Gold Plated ANL Heat Resistant Fuse Holder,(1)30 Amp ANL Gold Plated Fuse.Accessories: Wire ties, ring terminals, butt connectors, spades and grommet. Amplifier dimensions: 11 x 9.1 x 1.9 inches (L x W x H) Subwoofer dimensions: 28.7 x 14.2 x 15.7 inches (L x W x H).
50 Pack Solderless LED Tape Light Connector Screw Down Terminal Block Connector 2 Pin Led Connectors for Strip Lights 8 mm Tape to Wire for 5v 12v 24v Single Color LED Strip Lights, White
...Strong Compatibility: compatible with various sizes of linear, the LED adapter for strip lights is suitable for 22AWG, 20AWG, 18AWG, 16AWG solid wire, stranded wire and fuse wire, allows you to choose a more suitable customized solution, no worry about improper wiring.
Support High Current: these 8mm LED strip light connectors support up to 6A current and are compatible with 5V, 12V, 24V 2 pin LED strip, so that you can connect a longer LED strip through an LED connector.
How to Operate: these 2 pin connectors for LED tape are suitable for 2 pin 8mm IP65 LED waterproof light strip and non waterproof light strip, COB light strip and so on, if you want to connect your LED tape to the wire, just strip the silicone cover on the welding line area off the surface of the tape lamp, then insert the tape into the connector and tighten the screws.
Sufficient Quantity to Meet Your Needs: the package contains 50 pieces of 2 pin LED light strip connectors in total, come with mini size, compact and practical, sufficient to meet your various using needs on different occasions.
Features of dB12: Rockville dB12 2000 Watt Peak/500 Watt Dyno-Certified RMS Mono 2 Ohm Amplifier Car Amp, Dyno Certified RMS Power Ratings: (Certified Dyno Test / Less than 1 % THD) (Use these ratings when comparing with top brands such as Kicker, RF Fosgate, etc), - 2 Ohm: 500 Watts x 1 Channel.
- 4 Ohm: 1200 Watts x 1 Channel, High-Speed MOSFET Power Supply, Designed, Engineered, Developed, and Quality Controlled in the USA, Fully Adjustable 12dB / Octave Crossover with Differential Circuitry, Low Pass Filter: 50Hz - 250Hz, Subsonic Filter: 15Hz - 55Hz, Phase Control Switch 0-180 degrees, Full IC-Controlled Protection Circuitry, Remote Dashboard Subwoofer Control, Fully Adjustable 12dB Bass Equalizer, Mute and Delay Soft Start System, RCA Preamp Line Output.
