SAYGOHY Two Channels 48V Phantom Power Supply 2 Ways Condenser Microphone 48 V for Behringer C-3 C-1 C 1 3 C1 C3 Recording Mic, Black
1.Use the isolated voltage-boosting technology to effectively prevent the ground signal interference..
2.Use the built-in low-pass filter circuit design to fully filter out the interference noise from the external audio equipment..
3.Use soft-start function to avoid the impulsive sound of"puff" when booting the device..
4.Use two sets of balanced power supply,to balance the input and output signals,makes the voltage be balanced and stable,and inhibit common mode interference..
With 2-pin AC Adapter(110v~240v, 50~60Hz, Works Worldwide).
【Stable Performance】: FE-6J1-2 fever tube pre-amp board is the circuit schematic design imitation crew Music fax X-10D, to be rational optimization, more stable performance than the original machine, tube play 10% increase..
【12V AC Input】: Using a single 12V AC input, comes with boost function, low supply voltage to the effect of high-pressure tube..
【Clean Filter】: The capacitance filter of 8 470UFs is very clean..
【Excellent Power Supply】: Excellent power supply system to ensure that the four 470UF capacitor filter clean, tube filament is connected in series, DC 12V power supply, reducing noise..
【MET Series of Non-polar Capacitor】: Using MET series of non-polar capacitor, high-frequency low-resistance electrolytic capacitors, 1% precision metal film resistors, J-class military regulation tube 6J1..
BOSS Audio Systems CUBE10 Car Subwoofer and Amp Package – Built-in Amplifier, 10 Inch Subwoofer with Passive Radiator, Remote Subwoofer Control
...600 Max watt amplifier powers the 10” subwoofer.
Passive Radiator – A driver unit that has its motor structure (magnet) removed, becomes a passive diaphragm. As a result, there is no Chuffing that you would generally get with a ported box, thus enriching the BASS & making the system more linear.
Variable Low-Pass Filter - A low-pass filter is an electronic circuit that removes all the notes below the filter's frequency setting. You will use the Low-pass filter to primarily keep high notes out of your subwoofer(s).
High Level Input - Speaker level inputs are commonly referred to as high-level inputs. It will be used to connect the CUBE10 to your factory radio or an aftermarket radio that does not have low-level (RCA) inputs.
Phase Control - Phase control lets you adjust the speaker phase with the amplifier if your speakers or subwoofer are hooked up “out of phase”.
Low Level Input - Line level inputs, also known as RCA inputs or low-level inputs, use RCA interconnect cables to link the CUBE10 with the source unit. Most aftermarket radios have multiple pairs of RCA outputs that can connect to multiple amplifiers.
Variable Bass Boost - Variable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it.
