ACEIRMC SG90 Servo Motor Micro Servo 9G Servo Motor for RC Robot Arm Helicopter Airplane Remote Control (5 Pcs) (5pcs)
SG90 9G micro servo motor for remote control helicopters, micro robot, robot arm and boats. Fit for ALL kind of R/C Toys and also make electronics DIY based on compatible for Arduino ,Raspberry Pi.
The SG90 mini servo motor is lightweight, high-quality and lightning-fast.The servo is designed to work with almost all the radio control systems..
SG90 Micro Servo Motor compatible for Mini Arduino Servo SG90 9g Servo Kit for RC Helicopter Airplane Car Boat Robot Arm/Hand/Walking/Servo Door Lock Control with Cable.
The SG90 has 3 wire interfaces in which the connections should be made as follows: Red wire-5V, Brown Wire-Ground, Yellow wire-digital pin 9..
CenryKay MG90S Servo, Helicopter QC Module 9G Servo Motor Metal Gear Micro Servo Motor Smart Robot Helicopter Plane Boat for Arduino Raspberry Pi Project(6PCS)
Metal gear servo 9g is equivalent to the metal tooth plate of SG90. The installation size is slightly different from that of SG90. The servo system is more comfortable than cheap plastic gears..
Servo can rotate approximately 180 degrees (90 in each direction), and works just like the standard kinds but smaller..
This MG90S Micro Servo has metal gears for added strength and durability.It comes with a 3 horns (arms) and hardware..
The servo motors weight is 13.6g, suitable for 450 electric straight, swash plate steering gear, fixed-wing RC airplane..
The package included 6pcs MG90S Micro Servo, each MG90S come with one motor and three servo arms and three screws..
Case: NEMA 3R rated for indoor-outdoor installation. 9-3/8 (23.8 cm) high x 5-1/2 (14.0 cm) wide x 3-5/8 (9.2 cm) deep.
Knockouts: Combination 1/2 - 3/4 nominal knockouts, one on the back and each side of case, two pre-cut on bottom.
Timer: PB913N84 - 24 hour with 23-1/2 hour maximum on time. Two ON, two OFF trippers - standard. Dial will accept up to 12 sets of trippers. PB313E - 24 hour with 23 hours and 59 minutes max on time..
Globact RC Digital Servo Tester/ESC Consistency Tester for RC Helicopter Airplane Car(Servo Tester,ESC Consistency Tester,RC Helicopter Tester Tool)
【High Srecision】The RC ESC tester used to compare the performance steering gear control of the steering servo output signal can be accurate to 2us (1 milliseconds = 1000 microseconds).
【Keys Pulse Width】1. 50H analog servo signal cycle 20us frequency 50Hz, 2. 125H digital the steering gear a signal cycle 8us frequency 125Hz,3. 250H Digital Servo signal cycle 4us frequency 250Hz.
【Powerful Testing Function】RC plane servo tester can test the steering gear is able to respond to subtle changes With PPM signal test function in the display.
【How To Use】Digital or analog signal button selects the corresponding servo system and then plugs into the steering servo to avoid damage to the steering servo.
MakerFocus PWM Servo Motor Driver IIC Module 16 Channel PWM Outputs 12 Bit Resolution I2C Compatible with Raspberry Pi 4 3B+ 3B Zero/Zero W/Zero WH and Jetson Nano
Note: The Raspberry Pi and Servo in the photo are not included. User Manual: Please get the link from the operation guide below.
Note: 1.If you only connect 5V power supply to USB interface, servo cannot be driven.
2.You should connect higher power supply for higher-power servo.
3.Make sure servo are connected properly, otherwise they will not move..
Servo Motor Driver: You may have tried to control a robotic arm or a hexapod walker by using the Raspberry Pi, but finally get frustrated due to the limited number of PWM outputs and the jittering servo. Now you get a new option to bring your ideas to life, we prepare this useful Servo Driver Board for you..
Raspberry Pi connectivity, compatible with Raspberry Pi 4 3B+ 3B 2B+ 2B Zero/Zero W/Zero WH and Jetson Nano..
Up to 16-Channel servo/PWM outputs, 12-bit resolution for each channel (4096 scales).
Integrates 5V regulator, up to 3A output current, can be powered from battery through VIN terminal..
FEETECH 35KG Servo Motor 360 Degree High Torque Digital Servo High Voltage Waterproof Metal Gear Aluminium Case for RC Helicopter Airplane Car Boat Robot Controls - FT6335M
HIGH QUALITY SERVO: FT6335M servo motor is composed of a sturdy PA aluminum middle shell, a strong steel metal gear, and a hard iron shaft, provide higher stability and provide longer service life..
GREAT COMPATIBLE MOTOR: The servo motor system is controlled by pulse, compatible with 1/8 and 1/10 scale RC robots, trucks, off-road vehicles, robotic arms, and any application that uses a standard servo system..
SERVO PROTECTION MECHANISM: The steering gear has IP54 waterproof performance and ball bearings.The output torque exceeds the overload torque, lasts 8S, or the temperature over 70 ℃, the steering gear will automatically stop the output torque. The overload torque can be modified..
HIGH ROTATION SPEED SERVO: A high-torque servo, the rotation angle is 360 degrees (at 500→2500μsec), when the power is stopped, it can rotate 360 degrees. Dead width ≤ 4 μsec. Durable and reliable..
STRONG STALL TORGUE MOTOR: The operating voltage range is 4V-8.4V, the stall torgue is (6V) 400.65oz/in(28.8kg/cm), (7.4V) 493.86oz/in(35.5kg/cm). The servo size is 55X20x43mm..
BETU 35kg Waterpoof Servo, Full Aluminum Case and Stainless Steel Gear Servo, High Torque Servo Compatible with 1/6,1/8, 1/10, 1/12 RC Car/Robot/Boat
High Torque Servo:This 35kg Waterpoof Servo's maximum torque is up to 35 kg/cm@7V, high torque, Compatible with1/8, 1/10, 1/12 Truck, RC Car / Robot / Boat..
Waterpoof Servo: Waterproof performance IP67. Controllable angle range from 0 to 270 degrees, Excellent linearity, precision control..
All metal servo: Equipped with full aluminum case and stainless steel Gear, CNC aluminium middle shell, less noise, light weight, higher operating accuracy..
Product Dimension: 1.57 x 0.78 x 1.57 inch(40 x 20 x 40 mm).
With one 25T adjustable metal servo arm, one 25T round type servo horn and one set of accessories..
Great digital Servo for people who are interested in developing software for robot parts, Such as mechanical arm, Quadcopter Drone and other remote control equipment..
Miuzei 10 Pcs SG90 9G Micro Servo Motor Kit for RC Robot Arm/Hand/Walking Helicopter Car Boat Control with Cable, Mini Small Servos for Arduino Project
Application Fields: Miuzei SG90 9G Servo Motor Compatible with Remote Control Helicopters, Micro Robot, Robot Arm and Boats. Support All Kind of R/C Toys and Arduino Experiments.
Interface Type: This SG90 Servo Compatible With JR & Futaba Interface. Miuzei Micro Servo 9g no Load Running Speed: 0.09±0.01 sec/60° at 4.8V.
Miuzei Micro Servo Motor Stall Torque (4.8V): 17.5oz /in (1kg/cm).
NOTE: The Starting Current of The Analog Servo Motor Should Be Over 1A and Miuzei Servo SG90 are Analog Servos Need to Continuously Provide a PMW Signal, Then it Will Be Work Normally.
How to Reach 180 degree -- Miuzei SG90 9g Servo Motor Need to Meet 4.8V Power Supply Voltage and 2500usec Pulse Signal, the Angle of Rotation.