Aluminum 15 to 55 Gallon Drum Pump Rotary Hand Liquid Transfer Heavy Duty Rotary Barrel Pump Hand Drum Pump for Kerosene Gasoline Oil Fuel Diesel Hydraulic Fluid
Hand Drum Pump: The overall height of the pump is 51inch, the length of the oil outlet pipe is 39 inch, and the inner diameter of the oil outlet is 1.1" (28mm). oil outlet pipe can be adjusted to fit 15 to 55 gallon drums. Tip: only for oils. Note: Do not use it to pump water,it is not suitable..
Quality Aluminum: Our drum pump is made of high-quality all aluminum material, which is highly anti-corrosion and anti-rust, durable and lasts longer. Our 55 gallon drum pump supports clockwise transfer handle instead of counterclockwise transfer handle..
Applicable Type of Oil: Extractable liquid: Diesel oil, kerosene, engine oil, hydraulic oil, Gear oil, edible oil (but not edible grade). Liquids that cannot be extracted: Gasoline, water, urea, acid-base liquid, corrosive liquid, chemical liquid, edible liquid, etc. cannot be extracted..
Great Filter: Our hand liquid transfer drum pump distribution has a fine filter. You only need to install it at the bottom of the suction tube, which can effectively separate the oil dirt and oil, so as to ensure that pure oil is pumped..
Good Sealing: 3 piece segmented suction tube, easy to adjust the length of suction tube according to the actual situation, and easy to store and carry at the same time.suction tube with screw....
Vevitts 80w Oil Change Extractor Pump 12V Oil Extractor Pump for Changing Diesel Fluid Scavenge Suction Oil Transfer Pump Kits for Jet Ski, Truck, RV, ATV, Boat (Red)
【Instructions for use】1. Please pay attention to the direction of the inlet and outlet, the positive and negative poles and the locking hose lock before use.
2. Please start the vehicle and heat the engine oil to 40-60 degrees for about 5 minutes, otherwise, the oil change pump may have low suction or get stuck. 3. CAN NOT be used to extract water, gear oil (too viscous) or flammable liquid (fuel, gasoline,kerosene,etc.)..
【Complete Diesel Change Pump Kit】The oil transfer pump is mini but powerful. With 4.6ft Outlet tube & 4ft Inlet tube, the 8.2ft long battery clamps makes the extractor pump kit possible for being used at large range. The 2 hoops are used to tighten the tubes to avoid oil spilling..
【12V 80w Oil Extractor Pump】Oil change pump, a great helper for quick and clean oil changing and transfer, all parameter is verified by multiple test. Diesel Flow Rate: 3.5L/min, Engine Oil Flow Rate(40-60℃): 1L/min, Inlet Tube Length: 1.2m/47.2in, Outlet Tube Length: 1.4m/55.1in, Voltage: 12V, Maximum current: 5A..
【Premium Quality】We use pure copper for motors.Good conductivity, corrosion resistance and rust resistance, effectively avoid leakage or short circuit. Instead of manual operation, it can help you change oil quickly and cleanly....
THINKWORK Oil Pump for Oil Change, 12V 80W Electric Oil Pump and Marine Oil Change Pump, Upgraded Oil Change Pump Extractor with Handle for Boat, Car, Motorcycle
HANDLE PORTABLE OIL PUMP - Portable and small oil pumps are needed by everyone, simple operation does not need to spend too much time to practice, widely used in motorcycles, scooters, ships, quad bikes, trucks, ships, forklifts, Power generation machinery, tractors, lawn mowers and various machinery to change the oil..
QUICK OIL CHANGE - DC 12V 80W has enough power, you only need to clamp the conductive clip on the motor and open the switch to start it, so that you can complete the oil pumping work smoothly and effectively, replacing the traditional oil change method and reduce tedious workload (diesel flow: 1.5L / m, oil flow 0.3L / m)..
SAFE OPERATION - Except for engine oil and diesel, the oil pump must not draw any flammable liquid or water to avoid accidents. Before use, be sure to heat the car engine to 104 ° F-140 ° F (40℃-60℃) about 15 minutes to avoid clogging the oil pump due to oil solidification..
ACCESSORIES & PRECAUTIONS - The oil pump has 1 outlet hose, 1 inlet hose, 2 hose locks and 2 battery clips. Please pay attention to the direction of import and export, positive and negative poles and lock hose lock before use. The suction power of the micro suction pump is limited. Please do not connect other extension tubes..
VEVOR Vacuum Pump 12CFM 1 HP Single Stage Air Conditioning Vacuum Pump 110V 5PA Ultimate Vacuum Refrigerant HVAC Air Tool Rotary Vane Vacuum Pump for Automobile Vacuum Evacuation (1-Stage, 12CFM)
Heavy Duty Vacuum Pump: FAD: 12 CFM, Single Stages.
Ultimate Vacuum: 5 Pa. Our HVAC vacuum pump comprises heavy-duty aluminum alloy with durability and sturdiness. The strong copper motor provides continuous power, and a shock-proof base supports the stable operation..
Backflow Prevention: The refrigerant vacuum pump avoids chamber contamination by preventing oil from flowing back, otherwise polluting its container and tubes. 1/4" oil fill port makes oil adding simpler since the port is accessible from the front or either side. Oil drain hole makes oil drain faster, and the gas exhaust port can efficiently avoid oil spout..
Easy Monitoring & Cooling: With an oil viewing window, this AC vacuum pump can easily monitor oil levels to avoid oil deficiency. Our vacuum pump tool can cool itself and prevent itself from burning out. The built-in thermal protection prevents the machine from burning and extend the machine's life..
Ergonomic Grip Handle: The ergonomic grip handle is designed for superior comfort and portability. With the convenient handle, you can easily carry the vacuum pump to its destination..
Wide Application: The vacuum pump is widely used for commercial and household applications, suitable for cleaning a household air conditioner,....
Upgrade Oil Change Pump Extractor, 12V 60W Motor Oil Diesel Fluid Transfer Pump Quick Oil Extractor Pump Scavenge Suction for Car Boat Motorbike Tractor Truck RV ATV
HIGH EFFICIENT: This oil transfer pump is an ideal equipment for quick easy and clean safety oil-changes. Flow Rate: 3L/min flow rate for engine oil, 4L/min for diesel. Voltage: 12V, maximum current: 5A, maximum power: 60W..
APPLICATION: This oil pump can change engine oil and diesel for cars, tractor, boat, motorbike, truck, RV and ATV and other 12V vehicles..
EASY INSTALLATION: You just need to place the inlet/outlet hoses at the appropriate positions, tighten the hose clamps, connect the power clamps anode and cathode to the car battery properly and press the button. Oil will be extracted by itself..
NOTE: To pump oil properly, please start the vehicle to heat up the oil (to 40~60 degrees)about 15 minutes. Otherwise, the oil change pump may have low suction or jammed..
WARNING: This oil pump is not use to extract water, gearbox-oil(too viscous) or flammable liquids (fuel, petrol etc)..
PLUMIA 12V 100W Oil Change Pump Extractor, Upgraded Oil/Diesel Fluid Pump Extractor Scavenge Suction Transfer Pump, Marine Electric Oil Pump, For Boat, Car, Motorcycle, ATV, RV, Truck, Motorbike
【QUICK AND CLEAN OIL CHANGES】- Portable and small oil pumps are needed by everyone, simple operation does not need to spend too much time to practice, widely used in motorcycles, Car, scooters, Boat, quad bikes, trucks, Ship, forklifts, Marine, Power generation machinery, tractors, lawn mowers and various machinery to change the oil..
【SAFE OPERATION】- Except for engine oil and diesel, the oil pump must not draw any flammable liquid or water to avoid accidents. Before use, be sure to heat the car engine to 104 ° F-140 ° F, Avoid clogging the oil pump due to oil solidification..
【ENGINE OIL CHANGE MADE EASY】 - DC 12V 100W has enough power, you only need to clamp the conductive clip on the motor and open the switch to start it, so that you can complete the oil pumping work smoothly and effectively, replacing the traditional oil change method and reduce tedious workload (diesel flow: 1.7L / m, oil flow 0.35L / m)..
【ACCESSORIES & PRECAUTIONS】- The oil pump has 2*outlet hose, 2*inlet hose, 4*hose locks,1*screwdriver, 1*Oil-proof gloves, 2*battery clips, 1*user's manual. Please pay attention to the direction of import and export, positive and negative poles and lock hose lock before use. The suction power of the micro suction pump is limite....
DRIVESTAR M340 Engine Oil Pump 2004-2008 for Ford F-150/Expedition/Explorer/Mustang,for Lincoln Navigator/Mark LT 5.4L 4.6L
Fitment:Oil Pump for Ford 2005-2014 Expedition,2006-2010 Explorer,2007-2010 Explorer Sport Trac,2004-2010 F-150,2005-2010 F-250 F-350 Super Duty,2005-2010 Mustang,for Lincoln 2006-2008 Mark LT,2005-2014 Navigator,for Mercury 2006-2010 Mountaineer.
Deliver Oil:The oil pump can deliver a fixed quantity of pressurized oil to the engine, and keep it running smoothly. Which mean that your engine could always get the right amount of oil pressure, and the critical engine parts wouldn’t be rub together, or cause extensive and damage.
Strict Ex-Factory Testing:All products are manufactured in accordance with the international automotive spare parts production specifications, and passed strict testing before leaving the factory to ensure that each product quality is superior.
Note:When the certain engine parts don’t get enough oil, the engine may start to make tapping, knocking or rattling noises. Loss of oil pressure can prevent a vehicle from starting. And it’s time for a replacement of your failing oil pump..
Lotyes Quick Oil Change Pump, DC 12V 60W Oil Diesel Fluid Pump Extractor Transfer Pump & Tubes Kit for Car, Boat, Motorbike, Truck, RV, ATV and Other Vehicles
Efficient Extraction Pump: To pump your motor oil properly, please start the vehicle to heat up the oil (to 40~60 degrees)about 15 minutes! Otherwise, the oil change pump may have low suction or jammed. Lotyes oil change pump replaces manual operation and works by connecting the clamps to the vehicles 12V battery. It's high efficiency, rapid and saving effort..
Clean and Tidy: An ideal equipment for quick and clean oil changes. No more mess tools needed, the hoses and hose clamps in the package can prevent leakage during the extraction process..
Easy installation: Install the oil extractor inlet and outlet hose, tighten the hose clamps, connect the power clamps to the vehicles battery and switch the button on..
Versatility: This oil transfer pump can change engine oil and diesel for cars, boat, motorbike, truck, RV and ATV and Other Vehicles. WARNING: THIS PRODUCT CAN NOT USE TO EXTRACT WATER, GEARBOX OIL OR FLAMMABLE LIQUIDS(SUCH AS FUEL,PETROL,GASOLINE,ETC)..
What You Get: Lotyes oil extractor pump, outlet hose, inlet hose, hose clamps, battery clamps, user guide. We are certain that you will love the design and high quality of the product. Because you are our number 1 priority, we are offering premium customer support and money-back service for a risk....
Carefree Car and Boat Care: Easily remove engine oil, transmission fluid, power steering fluid, gear oil, coolant, and more with this versatile fluid evacuator pump.
Double Duty: For pneumatic extraction, insert the suction hose in the vacuum extractor pump receiving hole.
Manually suction fluid with the engine oil pump's oversized handle.
Don’t Cry Over Spilled Oil: The 9.5-gallon reservoir is a solid one-piece tank that can't leak out the bottom.
The built-in shutoff prevents overfilling the extractor pump reservoir.
Time Flies: Draining oil from beneath a vehicle takes eons.
The fluid pump's 5ft hose and dipstick adapter extracts automotive fluid directly from the dipstick tube.
Under Pressure: Change transmission fluid anytime with the pneumatic and manual pumping options.
This fluid extractor pump works at 85 PSI and a max pressure of 120 PSI.
YSTOOL 10L Pneumatic Fluid Extractor Dispenser Set ATF Refill Tool Kit for Changing Oil in Engine Transmission Differential Transfer Case Gear Gearbox Power Steering Coolant with Pump Assembly Tank
...way control valves (blue screw valve and air inlet ball valve) on the pump assembly to achieve the conversion between extracting and dispensing, very easy. Pneumatic tool, works with vacuum pump to extract and with air pump to refill, ensuring high efficient and labor-saving.
Pump assembly incorporates the container cover, the handle trigger with lock, 2-way control valves for conversing evacuate and dispense, safety valve for automatically releasing excessed pressure (above 43psi /3bar), 1/4" American style air inlet plug, pressure gauge (0-80psi/0-6bar) for monitoring the pressure change, quick coupler for connecting main hose. 10L big capacity well constructed container, is marked with accurate scale to help observe the amount of liquid. Stable base avoids dumping.
The main hose is 80" long, with a quick plug on one side to connect the container, and a quick coupler on the other side to connect the dipstick tubes or ATF adapters. There is a ball valve on the quick coupler to control the fluid flow, very convenient. Please note, there is no instruction in the kit, please refer to your vehicle operation instruction and following product description to operate. Your satisfaction and recognition are always what we pursue, please contact us to resolve an....
