Vevitts 80w Oil Change Extractor Pump 12V Oil Extractor Pump for Changing Diesel Fluid Scavenge Suction Oil Transfer Pump Kits for Jet Ski, Truck, RV, ATV, Boat (Red)
【Instructions for use】1. Please pay attention to the direction of the inlet and outlet, the positive and negative poles and the locking hose lock before use.
2. Please start the vehicle and heat the engine oil to 40-60 degrees for about 5 minutes, otherwise, the oil change pump may have low suction or get stuck. 3. CAN NOT be used to extract water, gear oil (too viscous) or flammable liquid (fuel, gasoline,kerosene,etc.)..
【Complete Diesel Change Pump Kit】The oil transfer pump is mini but powerful. With 4.6ft Outlet tube & 4ft Inlet tube, the 8.2ft long battery clamps makes the extractor pump kit possible for being used at large range. The 2 hoops are used to tighten the tubes to avoid oil spilling..
【12V 80w Oil Extractor Pump】Oil change pump, a great helper for quick and clean oil changing and transfer, all parameter is verified by multiple test. Diesel Flow Rate: 3.5L/min, Engine Oil Flow Rate(40-60℃): 1L/min, Inlet Tube Length: 1.2m/47.2in, Outlet Tube Length: 1.4m/55.1in, Voltage: 12V, Maximum current: 5A..
【Premium Quality】We use pure copper for motors.Good conductivity, corrosion resistance and rust resistance, effectively avoid leakage or short circuit. Instead of manual operation, it can help you change oil quickly and cleanly....
TonGass 7-29/32' Pool Skimmer Vacuum Vac Plate with Gasket (Glue NOT Included) Compatible with Hayward Skimmer Basket SP1082 1084 1085 1075 PN.SP1106
This is a must-have for your manual vacuuming needs. This vacuum plate fits for Hayward in-ground skimmer models SP1082, SP1084, SP1085, and SP1075.
7 29/32” DIAMETER SKIMMER VACUUM PLATE WITH 1 1/2” STRAIGHT ADAPTER - fit 7-inch skimmer baskets. They’re both equipped with a 1 1/2 inches straight vacuum hose connector that works best for in-ground pool skimmers.
With rubber gasket - permanently affixed on the bottom of the vacuum plate ensures a perfect vacuum seal between the skimmer surface and the vacuum plate.
NO NEED TO TURN THE PUMP ON AND OFF - The function of a skimmer vacuum plate is straightforward enough. It removes the need to connect the vacuum hose directly to the inlet, a common practice that can cause the skimmer to clog with large debris.
With the vacuum plate, you’ll be vacuuming from the skimmer basket instead of the pump’s strainer basket. There’s no risk of clogs and you don’t need to turn the pump off to install the vacuum hose.
THINKWORK Oil Pump for Oil Change, 12V 80W Electric Oil Pump and Marine Oil Change Pump, Upgraded Oil Change Pump Extractor with Handle for Boat, Car, Motorcycle
HANDLE PORTABLE OIL PUMP - Portable and small oil pumps are needed by everyone, simple operation does not need to spend too much time to practice, widely used in motorcycles, scooters, ships, quad bikes, trucks, ships, forklifts, Power generation machinery, tractors, lawn mowers and various machinery to change the oil..
QUICK OIL CHANGE - DC 12V 80W has enough power, you only need to clamp the conductive clip on the motor and open the switch to start it, so that you can complete the oil pumping work smoothly and effectively, replacing the traditional oil change method and reduce tedious workload (diesel flow: 1.5L / m, oil flow 0.3L / m)..
SAFE OPERATION - Except for engine oil and diesel, the oil pump must not draw any flammable liquid or water to avoid accidents. Before use, be sure to heat the car engine to 104 ° F-140 ° F (40℃-60℃) about 15 minutes to avoid clogging the oil pump due to oil solidification..
ACCESSORIES & PRECAUTIONS - The oil pump has 1 outlet hose, 1 inlet hose, 2 hose locks and 2 battery clips. Please pay attention to the direction of import and export, positive and negative poles and lock hose lock before use. The suction power of the micro suction pump is limited. Please do not connect other extension tubes..
Upgrade Oil Change Pump Extractor, 12V 60W Motor Oil Diesel Fluid Transfer Pump Quick Oil Extractor Pump Scavenge Suction for Car Boat Motorbike Tractor Truck RV ATV
HIGH EFFICIENT: This oil transfer pump is an ideal equipment for quick easy and clean safety oil-changes. Flow Rate: 3L/min flow rate for engine oil, 4L/min for diesel. Voltage: 12V, maximum current: 5A, maximum power: 60W..
APPLICATION: This oil pump can change engine oil and diesel for cars, tractor, boat, motorbike, truck, RV and ATV and other 12V vehicles..
EASY INSTALLATION: You just need to place the inlet/outlet hoses at the appropriate positions, tighten the hose clamps, connect the power clamps anode and cathode to the car battery properly and press the button. Oil will be extracted by itself..
NOTE: To pump oil properly, please start the vehicle to heat up the oil (to 40~60 degrees)about 15 minutes. Otherwise, the oil change pump may have low suction or jammed..
WARNING: This oil pump is not use to extract water, gearbox-oil(too viscous) or flammable liquids (fuel, petrol etc)..
PLUMIA 12V 100W Oil Change Pump Extractor, Upgraded Oil/Diesel Fluid Pump Extractor Scavenge Suction Transfer Pump, Marine Electric Oil Pump, For Boat, Car, Motorcycle, ATV, RV, Truck, Motorbike
【QUICK AND CLEAN OIL CHANGES】- Portable and small oil pumps are needed by everyone, simple operation does not need to spend too much time to practice, widely used in motorcycles, Car, scooters, Boat, quad bikes, trucks, Ship, forklifts, Marine, Power generation machinery, tractors, lawn mowers and various machinery to change the oil..
【SAFE OPERATION】- Except for engine oil and diesel, the oil pump must not draw any flammable liquid or water to avoid accidents. Before use, be sure to heat the car engine to 104 ° F-140 ° F, Avoid clogging the oil pump due to oil solidification..
【ENGINE OIL CHANGE MADE EASY】 - DC 12V 100W has enough power, you only need to clamp the conductive clip on the motor and open the switch to start it, so that you can complete the oil pumping work smoothly and effectively, replacing the traditional oil change method and reduce tedious workload (diesel flow: 1.7L / m, oil flow 0.35L / m)..
【ACCESSORIES & PRECAUTIONS】- The oil pump has 2*outlet hose, 2*inlet hose, 4*hose locks,1*screwdriver, 1*Oil-proof gloves, 2*battery clips, 1*user's manual. Please pay attention to the direction of import and export, positive and negative poles and lock hose lock before use. The suction power of the micro suction pump is limite....
DRIVESTAR M340 Engine Oil Pump 2004-2008 for Ford F-150/Expedition/Explorer/Mustang,for Lincoln Navigator/Mark LT 5.4L 4.6L
Fitment:Oil Pump for Ford 2005-2014 Expedition,2006-2010 Explorer,2007-2010 Explorer Sport Trac,2004-2010 F-150,2005-2010 F-250 F-350 Super Duty,2005-2010 Mustang,for Lincoln 2006-2008 Mark LT,2005-2014 Navigator,for Mercury 2006-2010 Mountaineer.
Deliver Oil:The oil pump can deliver a fixed quantity of pressurized oil to the engine, and keep it running smoothly. Which mean that your engine could always get the right amount of oil pressure, and the critical engine parts wouldn’t be rub together, or cause extensive and damage.
Strict Ex-Factory Testing:All products are manufactured in accordance with the international automotive spare parts production specifications, and passed strict testing before leaving the factory to ensure that each product quality is superior.
Note:When the certain engine parts don’t get enough oil, the engine may start to make tapping, knocking or rattling noises. Loss of oil pressure can prevent a vehicle from starting. And it’s time for a replacement of your failing oil pump..
Lotyes Quick Oil Change Pump, DC 12V 60W Oil Diesel Fluid Pump Extractor Transfer Pump & Tubes Kit for Car, Boat, Motorbike, Truck, RV, ATV and Other Vehicles
Efficient Extraction Pump: To pump your motor oil properly, please start the vehicle to heat up the oil (to 40~60 degrees)about 15 minutes! Otherwise, the oil change pump may have low suction or jammed. Lotyes oil change pump replaces manual operation and works by connecting the clamps to the vehicles 12V battery. It's high efficiency, rapid and saving effort..
Clean and Tidy: An ideal equipment for quick and clean oil changes. No more mess tools needed, the hoses and hose clamps in the package can prevent leakage during the extraction process..
Easy installation: Install the oil extractor inlet and outlet hose, tighten the hose clamps, connect the power clamps to the vehicles battery and switch the button on..
Versatility: This oil transfer pump can change engine oil and diesel for cars, boat, motorbike, truck, RV and ATV and Other Vehicles. WARNING: THIS PRODUCT CAN NOT USE TO EXTRACT WATER, GEARBOX OIL OR FLAMMABLE LIQUIDS(SUCH AS FUEL,PETROL,GASOLINE,ETC)..
What You Get: Lotyes oil extractor pump, outlet hose, inlet hose, hose clamps, battery clamps, user guide. We are certain that you will love the design and high quality of the product. Because you are our number 1 priority, we are offering premium customer support and money-back service for a risk....
