Memphis Audio SRXP62C 6.5 Inch 250 Watt Pro Car Audio Component Set with Mid Bass Driver Speakers, Tweeters and Crossovers for Stereo Sound System
COMPLETE AUDIO PACKAGE: Component set includes 2 SRXP62 6.5-inch mid-bass drivers, 2 tweeters, and 2 crossovers for a complete audio package.
POWERFUL PERFORMANCE: Speakers handle 250 watts of MAX and 125 watts of RMS per speaker for powerful performance.
HITS ALL FREQUENCIES: 1.5-inch voice coil allows for higher power handling while center phase plug improves high-frequency response.
THOUGHTFUL DESIGN: Paper cone and cloth treated surround allow for high sound pressure level (SPL), and accordion design provides increased excursion and output.
StriVectin Advanced Acids Hyaluronic Tripeptide Gel Cream for Eyes Intense Hydration & Blue Light Neutralizer 0.5 Fl Oz
Dual-phase formula delivers double the power: cooling gel phase helps deeply hydrate and correct while cream phase helps neutralize stressors and lock....
Slim Form Factor: At 7" in height, this subwoofer can be stored under most sofas and beds or on its side if there is space between the back of the couch and the wall.
Powerful Amplifier: Built-in 150W continuous / 300W peak high efficiency amplifier, 20Hz–180Hz frequency response with 40Hz–120Hz 12dB/Oct variable crossover, Auto/On/Off signal sensing, 0–180 degree phase control, and high level inputs with crossed high level outputs.
Bass to Unused Space: Offers flexibility and concealment without sacrificing floor space allowing for closer proximity to the listener for added tactile sensation and better bass response time.
Down Firing Woofer: 8" down firing active driver with 2" high temperature voice coil and santoprene surround increases output by using the floor as an acoustic amplifier.
Ported Enclosure: 3" side ported bass-reflex enclosure design is utilized to maximize output at your seating position and better low end extension.
Aitrip 5pcs TMC2209 V3.0 Stepper Motor Driver for 3D Printer SKR V1.3 SKR with heatsink 256 Microsteps Current 2.8A Peak for Reprap Ramps1.4 MKS Gen Mainboard Parts (5pcs)
TMC2209 V3.0 Stepper Motor Driver is an ultra-quiet two-phase stepper motor drive chip.
It can compatible with StepStick and Pololu A4988.
It can replace the original TMC2208, A4988, DRV8825, LV8729 and so on.
5 pcs Drive capability up to 1.7A (RMS) continuous coil current - 2.8A Peak.
Step/Dir interface with microstep interpolation (up to 256 microsteps).
The base of the protector adopts a rail type with two screw holes, which can be directly installed separately or mounted on the HT35 rail..
Use 5 indicators to indicate: normal, phase loss (voltage three-phase unbalance), reverse phase, overvoltage and undervoltage..
Phase loss protection means that when the protected line is in the running state or non-operating state, any phase failure occurs, and the delay is 2S..
Overvoltage protection means that the voltage of the protected line is higher than the set value, and the delay is 3~8S, and the recovery is 6~20VAC..
Reverse phase protection, a protection measure to prevent L1, L2, L3 three-phase AC phase sequence from being connected incorrectly, delay 2S action..
Siemens 3UG4631-1AW30 Monitoring Relay, Single Phase Voltage Monitoring, Screw Terminal, 1 CO Contacts, 0.1-60VAC/DC Measuring Range, 0.1-30V Hysteresis, 0-20s Delay Time, 24-240VAC/DC Auxiliary Voltage
3 INDICATORS-The protector base adopts 35mm rail type or device type, and has two screw hole structures inside, which can be directly installed separately or HT35 rail. Indicated by three indicators: normal, phase loss(voltage three-phase unbalance), reverse phase.
PHASE LOSS PROTECTION-Phase loss protection means that when the protected line is in the running state or non-operating state, any phase failure occurs, and the delay is 2S.
REVERSE PHASE PROTECTION-Reverse phase protection, a protection measure to prevent L1, L2, L3 three-phase AC phase sequence from being connected incorrectly, delay 2S action.
VOLTAGE IMBALANCE PROTECTION-Voltage imbalance protection, which refers to a protective measure that will affect the safe operation of the line due to three-phase voltage imbalance.
IDEAL FOR-Widely used in air compressors, electric motors, distribution boxes, water pumps, oil pumps, central air conditioning units, etc.
18 inch woofer with 60oz magnet and 3" voice coil. Great for parties, bars, weddings, meetings, speeches, churches, gymnastics, conferences, home theaters, etc..
Balanced XLR combo input and stereo RCA input ensures that left and right audio signal are both collected to avoid losing channel information.Stereo RCA output and full range XLR combo output. It also comes with filtered XLR output to export audio signal between 100Hz and 20KHz..
Selectable phase from 0°to 180°to run multiple subwoofers. Power-on and max volume indicators, crossover 40Hz-160Hz..
Lightweight but powerful: Built-in CLass-D amplifier ensures deep and thrilling stereo sound. Two side handles make it easy to transport. Weight: 68lbs.
Dimension:22”(W) x24.5”(D) x26”(H).
Super solid housing is made of plywood to reduces resonance for distortion-free and accurate response. Housing is also plated with special material for impact-resistance..
