Best Power Factor Compensation

Silverstone SX1000 Platinum, 80PLUS Platinum 1000W Fully Modular SFX-L Power Supply, SX1000-LPT V1.1

SFX-L form factor for use in small form factor computers.
1000W continuous power output rated for 24/7 operation.
Class-leading single +12V rail with 83.3A.
High efficiency with 80 PLUS Platinum certification.
Silent running 120mm dual ball bearing fan with advanced semi-fanless operation.
100% modular short cables with flexible flat arrays.
Strict ±3% voltage regulation and low ripple & noise.
24/7 continuous power output with 50℃ operating temperature.
High quality construction with all Japanese capacitors.

Antifreeze Refractometer for car. Designed for measuring coolant and antifreeze based on ethylene glycol or propylene glycol.
Requires only a few drops of sample Measurement in 2 seconds.
Power off: Meter will power off within one minute if no any operation.
With temperature display, freely switch operating. Automatic Temperature Compensation is an absolute necessity for refractometer.
Portable and Exquisite, Low power consumption, Anti-loss design.

...ition Auto-saving function: two voltage disconnect levels ,Charging power and current limitation function..
Support Lead-acid: Sealed (default)/ Gel/ AGM/ Flooded / User (9～17V@12V.
18～34V@ 24V) & Lithium: LiFePO4 (4s/12V.
6s/24V), User (9～34V) & User-defined.Battery temperature compensation function（only for Lead-acid battery) , Overheating power reduction function.
MT50 Remote Meter Automatic identify the controller, and display relevant parameter data , Diversified load control modes : Manual Control, Light ON/OFF, Light ON+ Timer, Time Control . RTS Temp sensor acquisition of battery(or controller) temperature for undertaking temperature compensation of control parameters,.
2022 Upgraded version support choose Lithium types by controller buttons directly . You could also contact with vendor(Goland Century) services to get program firmware upgrade file , then you could set old version controller's Lithium types by controller buttons too . More details parameters setting by EPEVER accessories ,such as MT50 ,eBox-WiFi-01 , eBox-BLE-01,elog01 ,PC software. Any questions please contact our USA Tech-support team ..

Frequency Response: 7 Hz - 500 Hz (+0, -1dB).
Min.Copper Power / Ground Wire Gauge: 4 AWG wire.
S/N Ratio, referred to 1 W: >50 dB (A-weighted, 20 Hz - 20 kHz noise bandwidth).

Main Specifications Product Description Belkin Pivot Plug Surge Protector surge suppressor.
Device Type Surge suppressor Form Factor External Output connector(s) 8.
Manufacturer Warranty Limited lifetime warranty General Device Type Surge suppressor.
Form Factor External Power Device Input Connector(s) 1 Output connector(s) 8.
Dataline Surge Protection Phone line - NOTE: THIS PRODUCT CANNOT BE SHIPPED TO MASSACHUSETTS OR DISTRICT OF COLUMBIA (WASHINGTON, D.C.).

High efficiency with 80 PLUS Gold certification.
350W Continuous power output at 40℃ operating temperature rated for 24/7 operation.

Frequency Response: 7 Hz - 500 Hz (+0, -1dB).
Min.Copper Power / Ground Wire Gauge: 4 AWG wire.
S/N Ratio, referred to 1 W: >50 dB (A-weighted, 20 Hz - 20 kHz noise bandwidth).

rogrammed Rapid Start T8 Ballast will accept up to 2 or 1 F32T8 lamps. Accommodates multi-voltages from 120 to 277-volts.
Runs quietly with most 120-volt applications, less than 10-Percent Total Harmonic Distortion.
Ballast factor rating of Low .77 for low power maximum savings, ballast factor rating controls light output and wattages of each lamp..

FEATURES: Normal power factor greater than 0.5.
Total harmonic distortion less than 139.1%.
LAMP COMPATIBILITY: Two F8T5, F13T5, or F14T5 lamps.
Designed to operate linear, compact, or circline fluorescent lamps.
INSTALLATION: Follow instructions while installing this product into your light fixture and use proper equipment.
Install in accordance with The National Electrical Code.