DUAL-CHANNEL - Connect up to 2x electric actuators with potentiometer feedback to have them travel in parallel, sequence, or individually.
SYNCHRONIZE - Connect devices with potentiometers to synchronize their movements.
SAVE UP TO 3 PRESETS - Use the wired remote to save 3x preset locations.
COMPATIBILITY - With a current rating of 15A, this control system is easy to use with a variety of 12VDC or 24VDC devices. Includes wire harness for each channel.
SPECIAL ATTENTION: Use it only with an actuator with potentiometer feedback. See at our Store PA-14P model..
DUAL-CHANNEL - Connect up to 2x electric actuators with potentiometer feedback to have them travel in parallel, sequence, or individually.
SYNCHRONIZE - Connect devices with potentiometers to synchronize their movements.
SAVE UP TO 3 PRESETS - Use the wired remote to save 3x preset locations.
COMPATIBILITY - With a current rating of 15A, this control system is easy to use with a variety of 12VDC or 24VDC devices. Includes wire harness for each channel.
SPECIAL ATTENTION: Use it only with an actuator with potentiometer feedback. See at our Store PA-14P model..
2.4KG Micro Digital Servo Kit - High Torque 9g Metal Servo Waterproof Mini Steering Gear Standard Fast Speed Continuous Rotation for SCX24 RC Model & EMAX ES08MD II Standard 180 Degree
...rful steering gear has passed the CE international safety test，which can withstand more than 1,000 impacts and increase your model's service life.
Stable performance: Compared with other steering gears, our upgraded high torque servo are equipped with high precision potentiometers and high-resolution digital chip, which can make your RC car respond quickly, enhance anti-interference ability, and quickly dissipate heat.
Light and portable: The weight of the mini SCX24 servo is only 12g and size is 23*11.5*24mm. Lightweight and small, which will not increase the burden of your RC car and slow down your RC car’s speed.
ElecGear 4X Replacement Joystick (EL2 FU 10K) for PS4 / PS3 Wireless Controller, Analog Stick Controller Sensor Assembly Thumbstick Module for Playstation
[EL2 FU 10K for PS4/PS3 Controller] – 4x replacement analog joystick was found in some PS4 DualShock 4 came with PlayStation 4 Pro, and some PS3 controllers also use this version. The thumbstick module was made by Favor Union (FU). The stick controller comes with 10KΩ trimmer potentiometers in orange.
[Compatibility] – The 14 prongs were positioned as the same as ALPS edition. Technically, the whole unit is interchangeable with EL1 ALPS 10K used in PS4 controllers, and other brands like ‘Scuf’ and ‘Razer Raiju Ultimate’ with ALPS joysticks inside. However, the trim pot resistor alone is not interchangeable with ALPS edition.
[Additional Resistor] – Complicated moving mechanism and daily wear and tear finally caused drifting. Even new sensors cannot be 100% balanced. Calibrating in controller settings might not work. We packed 10x correction resistors to solve the potential problem in hardware level. Solder one or two paralleled tiny resistors onto the potentiometer at the opposite direction against drifting. It will help correct 3 to 5 degrees drifting.
[When to replace] – The analog joystick needs to be replaced when your controller has the problem of drifting, creeping, stuttering, a blind spot, a dead spot, a dead zone, no react....
