ORCISH Battery Quick Connect Disconnect Electrical Plug 2-4 Gauge 175 Amps for Recovery Winch or Trailer (White)
Wide applications: the battery quick connector provides simple and convenient method for connect disconnect power to a winch or other electrical device such as remote battery chargers, power inverters, solar setups, trailers, or for any other purpose requiring a high-current, quick-disconnect connector.
Package comes with 6 sets 6-10 gauge battery quick connector, including 6 connectors, 12 terminal pins, 6 caps, enough quantity to meet your different needs or replacement.
Quality material: the battery quick connector plug is made of sturdy PC fire-retardant material with fitted rubber boot covers to protect against dust, moisture, have long service time.
Easily installation: you can install these battery cable quick connector disconnect plug quickly, insert the wires into the terminal pins, and then solder or crimp them, connector ends are identical, so either ends are suitable for connection to the power or load side.
Stable working environment: there are 12 terminal pins made of red copper coated with silver have strong electrical conductivity and reduce the resistance to ensure stable voltage and current.
DISPENSE YOUR FAVORITE BEVERAGES: Use the G. Francis Ball Lock Keg Fitting Ball Locks 12-Piece Ball Lock Quick Disconnect Set with Liquid & Gas Disconnects, Swivel Nuts, & Hose Clamps to ferment and dispense craft cocktails, soda, and other beverages from your existing keg.
USE YOUR KEG: Each of the ball lock keg connectors (fittings) have an approximate 2.2-inch height and 1.3-inch outside diameter (5.6cm x 3.3cm) and is compatible with ball lock Cornelius (Corny) kegs and keg couple adapters for homebrewing.
Hose clamps have 0.2-inch to 0.5-inch (6-12mm) diameter while the barbed swivel nuts have 5/16-inch outside diameter (OD) fitted for 1/4-inch or 3/16-inch inside diameter (ID) hoses on your 3, 5, or 10 gallon keg.
BUILT TO LAST: Keg ball lock quick disconnects and hose clamp wings constructed from ABS plastic that resists rust and corrosion.
Swivel nuts and clamps constructed from food-grade stainless steel for maximum strength and longevity.
INSTALL EASILY: Tighten the swivel nut connecting the flare fitting before use.
Ensure correct fittings are installed on input and output posts – Light gray disconnect for gas inlet and black disconnect for fluid outlet.