ACEIRMC 3pcs 20A 300W CC CV Step Down Module Adjustable DC 6-40V to 1.2-36V Voltage Regulator Buck Converter Constant Current Power Supply Module
Aceirmc buck converter input voltage range is DC 6-40V, adjustable output voltage range is DC 1.2-36V, can be used to convert 24v to 12v 5v, adjustable output current range is 0-20A, max output power is 300W. The step down regulator can apply to constant output current..
With a wide input voltage range from 6V to 40V, the step-down converter can accurately adjust output voltage and current. The efficiency can be up to 95%,(measured at 20A, converting 24V to 12V)..
Short Circuit Protection: Self-recovery(cannot short circuit for long time). Plus, when input and output is common grounded, no-load CV output constant voltage,CC output constant current.
Adopting 75V / 80A large current dual MOS tube designed step-down board, Input and output use high frequency low resistance electrolytic capacitor, low ripple, and gives a stable output. Large current 30A connection screw terminals, more convenient to install.
Application: DIY stabilized voltage supply, LED car display, mobile power, industrial equipment appliances, LED driver, monitor, solar energy, fans, photovoltaic energy, motor, etc....
Control Solutions Martins Viper Insecticide Concentrate 4oz
D-FENSE SC is a suspension concentrate insecticide for use both indoors and outdoors for effective knockdown and long residual control of listed....
Mix D-FENSE SC with water and apply using a hand pressurized or power operated sprayer, such as Actisol or similar equipment. For outdoor broadcast....
ePestSolutions also provides other pest control products which include ant control products , bed bug control , roach control & silverfish control....
D-Fense SC Insecticide with Deltamethrin is equal in strength to the popular Suspend SC Insecticide, but is much less expensive. D-fense SC is a....
ECO-WORTHY 10W PV Polycrystalline Solar Panel System kit W/ 3A Charge Controller & 30A Battery Clips
BATTERY CHARGE: Perfect for 12-volt battery charging.
CHARGER CONTROLLER: standby current 0.15mA for 3A 12V PWM battery charge controller. It offer overcharge and over discharge protection for the battery.
SPECIFICATION: Open-Circuit voltage (Voc): 20.6 Volt, optimum operating current (Imp): 0.58 Amps, short-circuit current :(Isc): 0.69 Amps. High modules conversion efficiency.
WATERPROOF& PORTABLE: Water-proof solar panel with 0.71 inch thickness resistant aluminum frame which allows the panels to last for 20 years.
PACKAGE CONTENTS: 1 x 13.26” by 8.04” by 0.71” solar panel: 1 x insulated battery clips with 78” extension wire: 1 x battery charger controller.
and all Porter Cable 18v cordless power tools and Porter Cable pcmvc pcxmvc charger.
Safe & Reliable:CE-/ROHS Certified for Security Assurances,100% New from Manufacturer.Built-in Protection against overcharging, over discharge, over current, provides short circuit protection and steady voltage circuit..
New from Manufacturer.Built-in Protection against overcharging, over discharge, over current, provides short circuit protection and steady voltage circuit..
At BAT INC, we provide 12-month product warranty,3 month money refund and perfect customer service!.
【Parameters】 -Model:Variable sliding potentiometer with knob.
【Material】 -The ceramic wirewound potentiometer is consisted of ceramic core and a resistive wire wrapped to form a toroid coil with a wiper axle..
【Features】 -The potentiometer carbon brush touches the resistance wire, and the resistance value is easy to adjust.
the rocker type manual operation, the alloy shaft, smooth and durable..
【Function】 -The rheostat is used for the regulation of voltage and current in power equipment and the middle circuit, and controls the resistance of the circuit without interrupting the current..
【Application】 -Ceramic wirewound potentiometer can be widely used as a motor speed regulator, suitable for pumps, fans and blowers or other applications that require high voltage and current..
NOYITO ACS758LCB-050B-PFF-T Linear Current Sensor Hall Current Module
This product is a current detection module, mainly using the ACS758-LCB current sensor. The ACS758 consists of a precision, low-offset linear Hall sensor circuit with a copper current path close to the wafer. The current applied through the copper current path is capable of generating a magnetic field that can be induced by the integrated Hall IC and converted to a proportional voltage.003cbr003e.
Device accuracy is optimized by placing the magnetic signal close to the Hall sensor. The accurate, proportional output voltage is provided by a stable chopper-type, low-bias BiCMOS Hall IC that is factory-precisely programmed.003cbr003e.
The internal resistance of this conduction path is typically 100 μΩ with low power loss. The thickness of the copper wire allows the device to operate under high overcurrent conditions. The terminals of the conduction path are electrically isolated from the sensor pins (pins 1 to 3). In this way, the ACS758 sensor IC family can be used in applications that require electrical insulation without the use of opto-insulators or other expensive insulation techniques.003cbr003e.
Perform RC filtering on the output and use the op amp to build a voltage follower circuit to make the output more stable and better match the impedance of....
(Taelectric) AC/DC Wall Battery Charger Power Adapter for LG BL-53YH G3 VS985 F400 D850
2 IN 1 USB Battery Charger. It can be used as not only a special charger, but also a charging plug for your device. Automatic constant current control prevents battery from overcharging. Smart LED indicator shows charging status: Pink/Purple shows that it is charging. Blue shows that it is charged fully. When the battery is fully charged,automatically stop charging..
Safety cut out circuit,Built-in protection circuit prevents overcharging. Constant current,constant voltage charging,automatic identification. Also convenient to interchange your spare batteries Use the data line which corresponds to mobile phone can be charged directly to the phone. Intelligent Chip: The smart chip protects from short circuit and overload by regulating voltage an ensuring a high effeciency charge. ..
Input: AC 100-240V 50/60Hz 150mA Output: DC 4.35V 600mA +/-50mA,USB Port Output: DC5.2V, 1000mA(USB) Connecter: US Plug Short circuit and overload protection Color: Black.
ITEM NAME AND APPLICATION: Three Pole Double Throw DPDT Knife Switch. Used for Fail-safe Circuit Breaker, Switching in Backup Generator, Power Switch, etc..
HIGH QUALITY: The knife switch is made of high quality copper and ABS, durable practical and stable performance. With the ABS cover, very safe to use..
SAFE AND RELIABLE: The double throw knife switch makes a solid connection and will draw quite a bit of current to make a safety guarantee..
Suitable for home and industrial appliances, convert between power system and self generator circuit..
Women Pajamas Set Sexy V-Collar Robe Lingerie Sling Nightgown Underwear Halter Nightdress Set Red
Low Power Consumption: The working current is about 25ua, the static current is about 6ua, the power consumption is very low..
Extend Life: Choose the right battery protection plate for your power tools, which can prolong the charging and discharging life..
High Safety: The board has various stable charging and discharging protection functions, such as over charging protection, over discharging protection and short circuit protection..
Reliable Use: Use the special integrated circuit of 5S lithium battery as the processor, detect real time voltage, current charge and discharge and ambient temperature of each battery..
For 5 Series Battery: This protection plate is suitable for 5 series lithium ion batteries, and is mainly used for power tools..
Minn Kota 1820175 Trolling Motor Marine Battery Power Center
This battery box / power center contains easy access external battery terminals that allow trolling motor leads and charger leads to be connected to the battery posts without opening the box.
Protects your battery (not included) on a small boat, transom application (boats that do not have battery compartments).
Built-in, push button battery meter with 4 LEDs displays current “state of charge”.
60A resettable circuit breaker connected to top.
10A resettable circuit breaker connected to two accessory ports.
Ring terminals on inside battery connectors.
Compatible with group 24 and 27 size batteries.
Overall dimensions: 7" x 13.5" wide x 12" tall.
Motor center ideal for small-boat transom applications.
Easy-access batter terminals for connecting leads.
Built-in battery meter displays current "state of charge".
Designed to fit group 24- and 27-size batteries.
Offers pair of 12-volt accessory plugs and manual reset circuit breakers.