Best Round Bend U Bolt

HiTow Trailer Hitch Tightener Anti-Rattle Stabilizer for 2' & 1.25' Hitch, Rubber-Coated No Rattle Noise, Corrosion Resistant

  • Compatible with all 1-1/4 inch and 2 inch Hitch, Rubber Coated.
  • Stops rocking, wobbling, banging, clanking and jerking caused by sloppy,take all the slop out, no rattle or fish tail, will providing a smooth and quiet towing experience.
  • Includes a heavy-duty U-bolt and thick powder coated plate that will stand up to all weather conditions and loads.
  • Easy installation by sliding the U-bolt over the stinger, sliding the tightener plate into the bolt, and tightening it in place with the included hardware, can be mounted from the bottom if hitch ground clearance is low.
  • Perfect for a variety hitch of SUV’s, vans, trucks, RV’s, sedans and trailers.
Check Stock

CertBuy 8 Pack Square U-Bolts 2-1/2 Inner Width 100mm Length 304 Stainless Steel U-Bolts with Washers and Nuts Replacement Parts and Accessories for Automobiles Trailer Ski Boat or Sailboat Trailer

  • Material: The U-bolt is made of 304 stainless steel, which ensures strength on the basis of easy to use, rustproof, scratch-proof and corrosion resistan..
  • Advantage: The 304 stainless steel U-shaped bolt with a higher rust-proof level has a longer service life under the conditions of sun exposure and high coastal salt..
  • Easy to Install: hook the U-bolt around a square post, adjust plate to desired position, and secure tightly in place with a hex nut on each leg..
  • Application: Used to fix or connect the locked parts to square products or sheet products, such as railing, wood, etc. Suitable for boats, plumbing, and other home and industrial applications..
Check Stock

Aopin Round U-Bolts 1-1/2 inch 38mm M6 Inner Width 304 Stainless Steel 8pcs Self-Locking Nylon Insert Hex Nuts Flat Washers for Car/Motorhome/Sailing Trailer Replacement Part and Accessorie 4Pack

  • STOP: ONLY USE a Hand Socket Ratchet or wrench to run the nuts up and tighten..
  • DO NOT USE an impact or powered socket driver. Ignoring this instruction will cause U-Bolt Galling / Seizing / Breaking / Failure / Expletives / Sawzall. Let's keep it Fun, and Successful..
  • U-Bolt Size: 1/2" Diam x 3- 1/16" Inside Width x 4- 5/16" Inside Height (Length).
  • Attention: When measuring for Your needed Height (Length), add 1" for the nut and washer..
  • Threading: 1/2"-13 with a thread length of 2- 1/2"..
  • U-Bolts and hardware are made out of 304 Stainless Steel..
  • These U-Bolts will fit on 3" x 3" cross members, such as 3" x 3" box steel..
Check Stock

REXBETI Staple Gun, Manual Brad Nailer Power Adjustment Heavy Duty 3 in 1 Staple Gun with 2600-Piece Staples for Upholstery, Fixing Material, Decoration, Carpentry, Furniture

  • Before use, make sure the strength adjustment bolt was already be tightened. If it came loose, be sure to tighten the bolt, or the loose bolt may pop out..
  • Comes with 1000pcs D-type, 800pcs U-type and 800pcs T-type staples to meet your different needs.
  • Rubber grip and convenience handle lock for comfort and safe.
  • When the staple gun is stuck, just pull down the metal drive channel and remove the stuck nails to ensure the nail gun works again.
  • Thick carbon steel construction for durability, multi-purpose allows easily insertion of D-type, U-type, T-type staples.Easy operation.
Check Stock

Crescent H.K. Porter Rebar Cutter and Bender - 0590RBJN

  • Pure Copper Motor: A pure copper motor ensures higher reliability and excellent motivation yet low noise. Moreover, it is more durable with less power consumption and low noise to extend the service life..
  • Excellent Performance: This portable rebar bender bending rebar up to 5/8'' (#5) grade 60 from 0-130 degrees within 5 seconds. It satisfies your various bending demand and raises your working efficiency significantly..
  • Solid Machine Body: Study and durable machine body and head can stand super-hard rebar with strong clamping force, which can help to reduce the waste of steel rebar. Multiple screws fixed on the head enforce the security..
  • Detachable Positioning Bolt: The Rebar Bender with adjustable positioning bolt allows you to accurately bend any angle within 0-130 degrees, preset angle for repeating the same angle bend..
  • Humanized Design: This portable automatic rebar bender features an ergonomic back grip design with two handles that facilitate maneuverability, ease of use, and security. Simply Keeping the switch pressed, the bending block starts to push forward..
Check Stock

REXBETI Staple Gun Manual Brad Nailer Power Heavy Duty 3 in 1 Staple Gun with 2600-Piece Staples for Upholstery Fixing Material Decoration Carpentry Furniture Staple Gun+Case+Remover

  • Before use, make sure the strength adjustment bolt was already be tightened. If it came loose, be sure to tighten the bolt, or the loose bolt may pop out..
  • Comes with 1000pcs D-type, 800pcs U-type and 800pcs T-type staples to meet your different needs.
  • Rubber grip and convenience handle lock for comfort and safe.
  • When the staple gun is stuck, just pull down the metal drive channel and remove the stuck nails to ensure the nail gun works again.
  • Thick carbon steel construction for durability, multi-purpose allows easily insertion of D-type, U-type, T-type staples.Easy operation.
Check Stock

Aopin Square U-Bolts 1.22inch 31mm Inner Width 304 Stainless Steel Silver M6 with Plates Nuts for Car/Motorhome/Sailing Trailer Replacement Part and Accessorie 4Pcs

  • Hex Nut: 14 x 6mm / 0.55" x 0.24"(Hex Width*H).
  • Frame Plate: 82 x 25 x 3mm / 3.23" x 0.98" x 0.1"(L*W*T).
  • Round Washers: 18 x 8 x 1mm / 0.71" x 0.31" x 0.04"(OD*ID*T).
  • Package Content: 4 x U-Bolt, 8 x Nuts, 8 x Round Washers, 4 x Plates.
  • Application: Used to fix or connect the locked parts to pipes, wood, etc. Suitable for boats, plumbing, and other home and industrial applications..
  • Material: Carbon steel constructed with great performance in antirust and corrosion resistance..
Check Stock

Heavy Duty 2.5 Inch Muffer Clamps Exhaust 2 1/2 Stainless Steel U Bolt Clamp on Tip Pipes Connection

  • Package Includes: One Piece 2-1/2” stainless exhaust clamp. It is made of T201 stainless steel with heavy duty U-bolt saddle design..
  • The 2.5“ exhaust hanger on exhaust with reinforced ribs on the saddle flange, expertly crafted and durable construction for long service. The high....
  • The stainless clamp is consisted of u-bolt, saddle flange and 3/8 Nuts..
  • Please check the detail information as belows. We value your shopping experience and strive to offer high quality product with sincere service. If you....
Check Stock

Durable Iron Solar Saddle Cover Holder Reel for Keeping Solar Cover Neat Easy Storage and Retrieval for Above Ground Pool, White, Pack of 5

  • Store Solar Cover: Keeping solar cover far from some places where makes it get dirty and muddy.
  • It not only can store cover firmly but also look neater. It brings order and neat instead of mess.
  • Study Tubing: Made by durable and weather-resistant iron, surrounding by baking varnish so that tubing is sturdy and has great capacity of load. Compare with others, snap on lock is upgrading in using.
  • U-tubes assembly do not require using screws except for installing the holder to the pool, reducing installation time and more convenient.
  • Easy to Install: Drill underneath top rails for 2 holes, fixing mounting brackets with rim of pool in 2 bolts. Link U-tube and other 2 tubes and fix with mounting bracket with bolt and acorn nut.
  • Only For Steel Sided Pools: Do not use it in soft side or metal framed pool walls.
  • What You Get: 5 pack of solar cover holders for you.
  • Welcome to contact us if you have any questions.
Check Stock

3M DBI-SALA 2103670 U-Bolt Roof Anchor (Permanent), Fits Up To 2X8, Silver

  • Makes attaching to the anchorage structure simple, fast and easy for added worker satisfaction and productivity.
  • Specialized fall protection system for residential or commercial wood frame structures keeps you safe and secure.
  • Everything required to install is included, simply place U-bolt over roof truss and install and tighten the bolts and clamp.
  • Provides a tie-off point for the contractor during construction, and also the homeowner for future maintenance of the roof.
  • Permanent U-bolt roof anchor with integral D-ring, flashing and cap, fits up to 2x8 roof member.
Check Stock