Best Shore C Durometer

Electrically Conductive Epoxy, Carbon Filled Adhesive, Room Temperature Cure, AA-CARB 61, 10gm kit

  • Spec. Gravity 1.35 g/cc Compressive Strength, psi 13,000 Pot Life 30 minutes Appearance Black.
  • Mechanical Properties Hardness, Shore D 85.
  • Vol Resistivity ohm. cm 003c 40 Operating Temp -50 to 145 °C Mix Ratio/weight 100:10 / Resin:Hardener.
  • Cure Time 24hrs At 25°C, 1 hr At 60°C , 15 minutes At 100°C.
Check Stock

Silver Epoxy, Electrically Conductive Adhesive, Highly Flexible Non-Bleeding AA-Duct 2919, 2.5gm kit

  • Spec. Gravity 2.32 g/cc Mixed Viscosity 995000 cP at temp 25.0 °C.
  • Mechanical Properties Hardness, Shore D 80 Adhesive Bond Strength 90 psi Lap shear 2 hrs At 65°C.
  • Electrical Properties Volume Resistivity 0.00011 ohm-cm,Dielectric Constant 4.8 At Frequency 1000 Hz.
  • Cure time 4 hrs At 65°C, 24.0 hour At 25°C.
Check Stock

HD Bumper Plates 2 Single - One 1 45 LB Single Rubber Weight Plate in Pounds LB for Olympic Barbells - Ideal for Cross-Training Weightlifting Fitness and Gym Weights 45lb Single Plate

  • ✅ SINGLES PLATES ONLY: This listing showcases SINGLE unit rubber plates for sale. If you wish to purchase a pair of bumper plates, please select....
  • ✅ PREMIUM QUALITY: Featuring the same high quality rubber polymer to achieve a low bounce and high durability, our new HD bumper plates feature....
  • ✅ IWF STANDARDS: Discover our premium HD Bumper Plates. These quality, budget-priced plates have the IWF standard 450mm regulated diameter and....
  • ✅ MINIMAL BOUNCE: Our bumper plates have an average of 90 on the Shore A Durometer scale, boasting an ideal hardness delivering a consistent dead....
  • ✅ BIG SELECTION: The HD bumper plates come in a selection of 10lb, 15lb, 25lb, 35lb and 45lb plates for Olympic barbells. Great for your garage....
Check Stock

Nickel Epoxy, Electrically Conductive Adhesive, Room Temp Cure, Air Dry, AA-DUCT 903, 50gm kit

  • Spec. Gravity 2.79 g/cc Cured Viscosity Paste, Solids contents % 100 Pot Life 30 minutes.
  • Mechanical Properties Hardness, Shore D 83, Shrinkage linear in/in 0.003.
  • Lap shear strength, psi 9400, Volume Resistivity ohm cm less than 0.038.
  • cure time 15 minutes At 100°C, 45 minutes At 50°C, 24 hours At 25°C.
  • Mix Ratio, parts by weight 100/5 Resin/Hardener, Operating Temperature -60 to 150 °C.
Check Stock

Nickel Epoxy, Electrically Conductive Adhesive, Room Temp Cure, Air Dry, AA-DUCT 903, 2.5gm kit

  • Spec. Gravity 2.79 g/cc Cured Viscosity Paste, Solids contents % 100 Pot Life 30 minutes.
  • Mechanical Properties Hardness, Shore D 83, Shrinkage linear in/in 0.003.
  • Lap shear strength, psi 9400, Volume Resistivity ohm cm less than 0.038.
  • cure time 15 minutes At 100°C, 45 minutes At 50°C, 24 hours At 25°C.
  • Mix Ratio, parts by weight 100/5 Resin/Hardener, Operating Temperature -60 to 150 °C.
Check Stock

210 Silicone O-Ring, 70A Durometer, Red, 3/4' ID, 1' OD, 1/8' Width (Pack of 100)

  • Made of silicone for use with a variety of chemicals and fluids.
  • Can be used across a wide temperature range from -65 degrees F (-54 degrees C) to 450 degrees F (232 degrees C).
  • Round in cross-section to provide a seal between cylindrical overlapping surfaces.
  • Durometer (hardness) of 70A for resistance to penetration.
  • Meets standards defined by Aerospace Standard AS568A.
Check Stock

High Temperature Thin Transparent Silicone Rubber Sheet with Adhesive, 60 A Durometer, 0.04" Thickness, 6.3" Width, 11.8" Length

  • Resistant to ultra-violet light, ozone and weathering processing,pharma ceutical and cosmetic manufacturing area.
  • High temperature silicone has a durometer of 60, Good electrical insulation.
  • Excellent resistance to heat (dry air), at +260º C continuous and +260º C intermittent.Remains flexible at low temperatures of -40ºC.
  • Package included: 300×160(11.8×6.3 inch) x1.0mm Clear silicone rubber sheet with Adhesive.
Check Stock

papababe Bumper Plates Set 2-Inch, Color Coded Olympic Weight Plates, Weight Plate Set with Steel Insert for Weightlifting in Home Garage Gym (45 LB, Pair)

  • 【Durable & Tough】Made of one-piece molded virgin rubber, bumper plates have been drop-tested 30,000 times, shore durometer is 90. Firm enough to avoid scratches or crack after dropping from an overhead position..
  • 【Safe & Quiet】The high density of rubber helps a dead bounce for max safety. Rubber weights plates set have less noise. Ideal for home and garage gym use..
  • 【 Less movement on the bar】With reinforced stainless steel insert in the center to minimize the chance of separation. Hold snug in the bar’s sleeve and no worry about sliding..
  • 【Upgrade color codes 】Raised yellow text helps to find 35 lb bumper weights quickly and look nicer than a pure black one. The raised lip also protects the printed letter from wearing off..
  • 【Standard Olympic size】17.5 inches / 450 mm in diameter, thickness varies by barbell weights. Fits 2" Olympic bars and 2" weight trees. Sell in pairs or sets for various needs..
Check Stock

papababe Bumper Plates Set 2-Inch, Color Coded Olympic Weight Plates, Weight Plate Set with Steel Insert for Weightlifting in Home Garage Gym (10 LB, Pair)

  • 【Durable & Tough】Made of one-piece molded virgin rubber, bumper plates have been drop-tested 30,000 times, shore durometer is 90. Firm enough to avoid scratches or crack after dropping from an overhead position..
  • 【Safe & Quiet】The high density of rubber helps a dead bounce for max safety. Rubber weights plates set have less noise. Ideal for home and garage gym use..
  • 【 Less movement on the bar】With reinforced stainless steel insert in the center to minimize the chance of separation. Hold snug in the bar’s sleeve and no worry about sliding..
  • 【Upgrade color codes 】Raised white text helps to find 10lb bumper weight plates quickly and look nicer than a pure black one. The raised lip also protects the printed letter from wearing off..
  • 【Standard Olympic size】17.5 inches / 450 mm in diameter, thickness varies by barbell weights. Fits 2" Olympic bars and 2" weight trees. Sell in pairs or sets for various needs..
Check Stock

Low Cost, 1 Part Heat Dry Electrically Conductive, Silver Epoxy Adhesive AA-DUCT AD1, 2.5gm Syringe

  • Mixed Viscosity 6800 cP, Density gm/cc 2.35, Silver percentage 65-75.
  • Mechanical Properties Hardness, Shore D 83, Pot Life 6 months At 25 °C 9 months refrigerated.
  • Sheet Resistivity 10-12 m?/sq, Lap shear strength 2000 Lb/in2.
  • Cure Time 0.7 hours At 200 °C, 1.5 hours At 180 °C, 2.5 hours At 160 °C.
Check Stock