Best Spi Connecting Rods

Gymnastics Bar for Kids, Gymnastics Horizontal Bar Blue, Gymnastics Training Bar, 4 Levels Adjustable Height Horizontal Bars for Home, Gift for Teens, Child, Boys, Girls

  • ...and shock absorption and protect your floor from scratches, avoiding possible safety issues during use..
  • ❤️【4 adjustable heights】Junior training bar has 4 adjustable heights (35.4in/40.6in/45.7in/51.2in) and is equipped with elastic locking knobs, and 4 heights have visible small hole marks. Just pull up the connecting rods on both sides of the bar to finish folding in a few seconds..
  • ❤️【Enhanced Safety Design】The gymnastic horizontal bars are made of durable strong steel with a smooth powder coating surface and non-slip rubber sleeves on the bottom for quality and safety..
  • ❤️【Space Saving and Easy Carrying】Our gymnastics kip bars are specially designed for family use. When you don't use this kip training bar, you can complete the folding in a few seconds by pulling the connecting rods on both sides. The minimum size is 42.5 in x 18.5 in x 33.4 in(22 lbs), and it can be placed in the corner at will..
Check Stock

Adafruit 4201 Airlift – ESP32 WiFi Co-Processor Breakout Board

  • a breakout board that lets you use the powerful ESP32 as a WiFi co-processor..
  • Having WiFi managed by a separate chip means your code is simpler,.
  • Send basic but powerful socket-based commands over 8MHz SPI for high speed data transfer.
  • We placed an ESP32 module on a PCB with level shifting circuitry, a 3.3V regulator, and a tri-state chip for MOSI so you can share the SPI bus with other devices.
Check Stock

Happymodel Mobula6 1S 65mm Brushless Whoop Drone Mobula 6 BNF AIO 4IN1 Crazybee F4 Lite Flight Controller Built-in 5.8G VTX (Frsky RX,19000KV)

  • Flight controller: CRAZYBEE F4 Lite Firmware target: Frsky SPI RX version is CrazybeeF4FR.
  • Flysky version is Crazybee F4FS. Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready. Built-in Betaflight OSD(SPI Control). Built-in 5.8G VTX. Built-in SPI Frsky/Flysky receiver. Built-in 5V 1A BEC. Built-in voltage detection..
  • Onboard 4in1 ESC: MCU upgraded to EFM8BB21 Power supply: 1S LiPo/LiPo HV Current: 5A continuous peak 6A (3 seconds) Support BLHeliSuite programmable Factory firmware: O_H_5_REV16_7.HEX Default protocol: DSHOT600.
  • Runcam Nano3: Horizontal Resolution: 800TVL Lens : 2.1mm(M8) FOV 160° Signal System: PAL/NTSC Non Switchable Day/Night: Color.
  • Onboard 5.8g 40-CH 25mw VTX: Input voltage: 3.3V 5.5V Current consumption: 300mA(type) Frequency: 5.8GHz 5bands 40 channels Smartaudio ready.
Check Stock

2.9inch E-Ink Display Module 296x128 Pixel White,Black Two-Color 3.3V/5V E-Paper Screen LCD Support Partial Refresh SPI Interface for Raspberry/Jetson Nano/Ard/Nucleo

  • 2.9inch, 296x128 resolution, with embedded controller, communicating via SPI interface, supports partial refresh. Due to the advantages like ultra low power consumption, wide viewing angle, clear display without electricity, it is an ideal choice for applications such as shelf label, industrial instrument, and so on..
  • Display color: black, white. Grey level: 2. Partial refresh time: 0.3s. Full refresh time: 2s. Refresh power: 26.4mW(typ.). Standby power: 170°..
  • Interface: 3-wire SPI, 4-wire SPI. Outline dimension: 89.5mm × 38mm. Display size: 66.89mm × 29.05mm. Dot pitch: 0.138 × 0.138..
  • Onboard voltage translator, compatible with 3.3V/5V MCUs.Operating voltage: 3.3V/5V. Ultra low power consumption, basically power is only required for refreshing.No backlight, keeps displaying last content for a long time even when power down.
Check Stock

Timken NTA5266 Needle Bearing

  • Widely used for connecting model cars, model ships, robots, etc..
  • This joint or coupling connects rigid rods whose axes are inclined to each other..
  • Made of premium metal material, it is durable and has long service life..
  • It is commonly used for shafts that transmit rotary motion..
Check Stock

Timken B4416 Needle Bearing

  • It is commonly used for shafts that transmit rotary motion..
  • Widely used for connecting model cars, model ships, robots, etc..
  • Made of premium metal material, it is durable and has long service life..
  • This joint or coupling connects rigid rods whose axes are inclined to each other..
Check Stock

BSN Rigid Drag Mat 6-feet x 18-inch

  • Rugged all-steel drag mats have 1" x 1" mesh with 13 gauge galvanized connecting rods.
  • Mesh material is 3/8" x .050 galvanized steel.
  • Includes heavy-duty angle iron across front of mat and a rope with handle for pulling.
Check Stock

InstallGear IGDLA-2 Universal Car Power Door Lock Actuators 12-Volt Motor (2 Pack)

Check Stock

Xanter Metal Sphere Gold Small

  • Made from 3/8 inch thick solid aluminum rods. Casted and welded into connecting loops with a beautiful plated finish.
  • This metal decorative sphere is perfect for filling large glass bowls, vases and more.
  • Display it in your home for a simple, yet interesting touch.
  • Can be used to compliment your current decor scheme or make it the focal point of the room.
Check Stock

Baseball Infield Drag Mat

  • Rugged all-steel drag mats have 1" x 1" mesh with 13 gauge galvanized connecting rods.
  • Mesh material is 3/8" x .050 galvanized steel.
  • Includes heavy-duty angle iron across front of mat and a rope with handle for pulling.
Check Stock