ABN Professional Brake Line Flaring Tool Kit 45 Degrees - Single Bubble Double Flare Tool Kit for Steel Copper Tube
...proof Connection]: When building car brake lines, the ABN Professional Brake Flaring Tool Kit adds a flare (makes tubing wider) to brake line end for a leak-free connection without hours of hand cramping or twisting exercises.
[Fits Your Application]: 45-degree set creates single, bubble, and double flares on steel, stainless steel, and soft metal (copper, aluminum) brake lines, transmission cooler lines, and fuel lines.
For 3/16-inch (4.75mm), 1/4-inch (6.35mm), 5/16-inch (8mm), and 3/8-inch tubing.
[Use Your Vise]: Use on a bench-mounted vise in your workshop or on a hitch-mounted vise in the field (not intended for use under car).
6-inch (15.2 cm) T-handle screw clamp holds die and tube in place so you can create flares quickly and easily.
[Durability You Need]: Deburred square pipe end with outer edge chamfered approximately 0.25 x 45 degrees.
Each die block is 1.7 inches (4.3 cm) long.
Approximate 1.5-inch (3.8 cm) actual clamping surface [we recommend only placing bends in the last 2.5 inches (6.4 cm) of tube after flared].
[Package Contents]: Brake line flare kit includes (1) brake line flare tool with T-handle and 11-inch lever with 5-inch texturized rubber sleeve (27.9x12.7 cm), (4) end dies, (1) instruction manual, and (1) 14.1 x 6.1 x 3.5 inch....
This dimple die set creates flared holes most commonly used on automobile parts fabrication. Cut out holes inherently provide reduced weight of the work piece, and these dimple dies create rigidity by flaring the holes..
Die Material: Punch Grade Hardened Tool Steel, Black Oxide Finish..
This dimple die set works with a hydraulic driver and cylinder tool most commonly used with hydraulic knockout sets like our TEMCo THA043 and TH0372..
The special cone eccentric revolution allows the internal opening gradually and accurate from 45° and regual flare without effor, preventing tube....
Eccentric cone will be rebound automatically after the work is finished, make the idle top head in revolution again for 1-2 times and have the flare....
Flexzion Flaring & Swaging Tool Kit 45 Degree Tubing 1/8 to 3/4 inch for Soft Copper Tube Extrusion Type Water Gas Line Automotive Plumbing 14 Pieces Cone with Portable Carring Case
Copper tubing flaring + swaging kit in a combination tubing flaring./swaging kit to fit all your needs.
For 1/8",3/16",1/4",5/16",3/8",7/16",1/2",5/8"& 3/4" O.D. Tubing.
The 45 degree cone for flare. 5 Swage Adapters For: 3-in-1 (3/16",1/4",3/8") ,5/16",1/2",5/8"& 3/4" O.D.Tubing.
Swivel type Swaging adapters and flaring cone are hardened steel chrome finished for easy operation.
Self centering, slip-on forged steel yoke. All in a hand carrying plastic case red color box.