Carrier/Backing: solid acrylic material. Adhesive: general-purpose acrylic. Release Liner: red PE film. Thickness: 25 mils (carrier, adhesive) 20 mils (carrier) 5 mils (liner)..
Adhesion: 192 ounces per inch (to stainless steel test panel). Tensile Strength: 100 pounds per inch (longitudinal). Service/Operating Temperature: up to 200F. Application Temperature: 50F to 100F. Density: 60 pounds per cubic foot. Dynamic Overlap Shear: 70 pounds per square inch. Short Term Temperature Resistance: up to 300F. Core: 3-inch diameter..
PC Products 72561 PC-Concrete Two-Part Epoxy Adhesive Paste for Anchoring and Crack Repair, 8.6 oz Cartridge, Gray (Fоur Расk, Gray)
Two-part epoxy adhesive paste to fill and repair cracks in concrete, and to anchor threaded rods, bolts, and dowels into concrete, grout-filled block, and unreinforced masonry.
High-tack paste resists moisture for application in damp environments and can be used in vertical applications.
Can be used in indoor and outdoor applications with an application temperature range from 35 to 115 degrees F and a service temperature range from -20 to +115 degrees F.
Provides work time of 20 minutes and cure time of 4 hours (at 75 degrees F).
Everrich Automotive Electric Silicone Heating Pad, 5.11 x 3.54 Inch 110V 120W – Waterproof High Heat Transfer Car Heated Wrap Mat
1.KEEP ENGINE WARM: On a cold winter day, use the Everrich Automotive Electric Silicone Heating Pad, 5.11 x 3.54 Inch 110V 120W – Waterproof High Heat Transfer Car Heated Wrap Mat 10 or 15 minutes prior to start up for perfect engine oil temperature.
Device heats the oil quickly for those cold start mornings..
2.SAFE AND FAST HEATING: Uniform temperature, high thermal efficiency, high strength, easy to use, safe life for up to two years, not easy to aging.Well waterproof performance, fast temperature rising, temperature uniformity,High thermal efficiency, well toughness. Conform to the American UL94 level V0 flame resistant standard..
3.EASY INSTALLATION- Use pressure-sensitive adhesive to stick it on the flat and smooth artifacts, The maximum service temperature of pressure sensitive adhesive: 150 degrees Celsius Continuous temperature, 220 degrees Celsius instantaneous temperature. Silicone rubber heater with pressure sensitive adhesive should be used in half a year after processing, otherwise it will influence on the performance of the glue using.Can be directly tied to the surface of heated objects..
4.WIDE APPLICATION: Fit for All kinds of automobile fuel tank, water tank, storage battery, anti-freezing heat insulation.The silicon rubber ....
